Multi-objective optimization of wire electrical discharge machining of 20MnCr5 alloy steel. (9th March 2020)

• Record Type: Journal Article
• Authors: Kumar, Naresh; Goyal, Khushdeep
• Is Part Of: World journal of engineering. Volume 17:Number 3(2020)
• Page Start: 325
• Page End: 333
• Publication Date: 2020-03-09
• Subjects: WEDM -- Taguchi -- Orthogonal array -- Process parameters -- MRR -- SR and 20MnCr5; Engineering -- Periodicals; 620
• DOI: 10.1108/WJE-09-2017-0304
• Languages: English
• ISSNs: 1708-5284

Abstract

Abstract : Purpose: Wire electric discharge machining (WEDM) is a non-conventional machining process, which is used to provide difficult and intricate shapes. The purpose of this research work is to apply Taguchi's technique to optimize the process parameters in WEDM. Alloy steel 20MnCr5 has been selected as base material for experimentation. The effects of the input process parameters such as wire type, pulse-on time, pulse-off time, peak current, wire feed rate and servo voltage have been calculated on the material removal rate (MRR) and surface roughness (Ra) in WEDM operation. Design/methodology/approach: In the research work, Taguchi's technique is applied to optimize the process parameters in WEDM. Findings: ANOVA indicated that pulse-off time was the most significant factor for the MRR, and servo voltage was the most significant factor for surface roughness (SR). As a part of the project, 20MnCr5 was machined in wire electric discharge machine, and the optimal control parameters were found to get higher MRR and better SR using Taguchi's technique. Originality/value: To the best of authors' knowledge, after reviewing the literature, materials including alloys of metals such as 16MnCr5 and 20MnCr5 have not been investigated so far, and research regarding machining of these materials is limited. Therefore, 20MnCr5 material has been selected for this research work to generate WEDM data.