Low cost irregular feed stock for laser powder bed fusion. (October 2018)

• Record Type: Journal Article
• Authors: Rogalsky, Allan; Rishmawi, Issa; Brock, Lisa; Vlasea, Mihaela
• Is Part Of: Journal of manufacturing processes. Volume 35(2018)
• Page Start: 446
• Page End: 456
• Publication Date: 2018-10
• Subjects: Additive manufacturing -- Laser powder bed fusion -- Irregular metal powders -- Powder flowability -- Powder bed density -- De-powdering artifacts -- Water atomized iron -- Inconel625; Production management -- Data processing -- Periodicals; Manufacturing processes -- Periodicals; Procestechnologie; Productietechniek; Production -- Gestion -- Informatique -- Périodiques; Fabrication -- Périodiques; Manufacturing processes; Production management -- Data processing; Periodicals; 670.5
• DOI: 10.1016/j.jmapro.2018.08.032
• Languages: English
• ISSNs: 1526-6125

Abstract

Abstract: Spherical powders are almost exclusively deployed for metal laser powder bed fusion (LPBF) additive manufacturing (AM). In this work, low-cost irregular powder feedstock is studied for its potential in three key areas to meet minimum AM process requirements, namely: (1) hopper flow, (2) layer spreading, and (3) de-powdering. Irregular water-atomized Iron powder was used as the study population, while spherical plasma-atomized Inconel 625 powder was used as the control. Powder flow characteristics were obtained using a FT4 Powder Rheometer (Freeman Technology). Layer spreading was evaluated indirectly via powder bed density measurements. Measurements were quantified by using printed artifacts for captive powder and evaluated using isopropanol infiltration and three-dimensional computed tomography (CT) imaging (Zeiss Xradia 520 Versa). Powder clearing from fine channels was quantified through vision-based measurements of printed artifacts (Dino-Lite DinoCapture 2.0). The results from this work demonstrated that: (1) A larger opening and steeper hopper angle are necessary to maintain a mass flow regime with the irregular powder. (2) Powder bed density is similarly consistent across the bed indicating adequate spreadability. (3) Water-atomized Iron powder has better de-powdering characteristics in the smallest cleared 0.6 mm diameter features, likely due to its 15% lower bed density.