Nanoparticle layer detachment and its influence on the heat transfer characteristics in saturated pool boiling of nanofluids. (October 2018)

• Record Type: Journal Article
• Authors: Watanabe, Yosuke; Enoki, Koji; Okawa, Tomio
• Is Part Of: International journal of heat and mass transfer. Volume 125(2018)
• Page Start: 171
• Page End: 178
• Publication Date: 2018-10
• Subjects: Saturated pool boiling -- Nanofluid -- Nanoparticle layer -- Peeling test -- Adhesion force -- Critical heat flux -- Heat transfer coefficient; Heat -- Transmission -- Periodicals; Mass transfer -- Periodicals; Chaleur -- Transmission -- Périodiques; Transfert de masse -- Périodiques; Electronic journals; 621.4022
• DOI: 10.1016/j.ijheatmasstransfer.2018.04.072
• Languages: English
• ISSNs: 0017-9310

Abstract

Highlights: First experimental data were provided for the adhesion force of nanoparticle layer. HTC deterioration and CHF enhancement were reduced by nanoparticle-layer detachment. Even higher HTC and lower CHF than those for bare surface were measured. Abstract: In nucleate pool boiling of nanofluid, nanoparticles suspended in liquid are deposited to form nanoparticle layer on the heated surface. As a result, surface properties are changed and the critical heat flux (CHF) is usually enhanced. However, since adhesion of the nanoparticle layer to the heated surface is not necessarily strong, partial detachment of the nanoparticle layer frequently occurs during nucleate boiling. In this study, peeling test was conducted for the nanoparticle layer formed during nucleate boiling of the water-based nanofluids to measure the adhesion force. The material of the heated surface was copper, and TiO2, Al2 O3 and SiO2 were used as the nanoparticle material. It was found that the adhesion force is highly dependent on the nanoparticle material; it was greatest for SiO2 and weakest for TiO2 in the present experiments. Then, saturated pool boiling curves were obtained using the damaged heated surfaces after the peeling. For the nanoparticle-layer coated surfaces without peeling, the heat transfer coefficient (HTC) was lower and CHF was higher than those for the bare surface. It was shown that with an increase in the mass of the nanoparticles removed by peeling, the decrease of HTC and the increase of CHF were mitigated. Even higher HTC values and a lower CHF value than those for the bare heated surface were measured for significantly damaged surfaces.