Removal of metals from mine drainage waters by in situ mineral sorbent-based pilot filter systems. (15th April 2019)

• Record Type: Journal Article
• Authors: Postila, Heini; Heiderscheidt, Elisangela; Leiviskä, Tiina
• Is Part Of: Journal of environmental management. Volume 236(2019)
• Page Start: 631
• Page End: 638
• Publication Date: 2019-04-15
• Subjects: Purification efficiency -- Mining waters -- Slag -- Recycled mineral -- Sorption; Environmental policy -- Periodicals; Environmental management -- Periodicals; Environment -- Periodicals; Ecology -- Periodicals; 363.705
• DOI: 10.1016/j.jenvman.2019.01.115
• Languages: English
• ISSNs: 0301-4797

Abstract

Abstract: Discharge of metal-containing wastewater streams into the environment is an environmental concern because these pollutants do not degrade and tend to bioaccumulate. A number of laboratory-based investigations on the effectiveness of a wide range of filter materials for metal removal from diluted wastewater streams have been reported. However, only a few pilot or full-scale investigations have been conducted. Therefore, this study investigated the metal retention capabilities of mineral-based filter materials (commercially available mineral product (5–15 mm), recycled mineral material (2–4 mm) and slag by-product (2–4 and 4–16 mm)) when used in pilot-scale filter systems under continuous operation in a closed mining area in North Ostrobothnia, Finland, between June and October 2017. The influence of material particle size on system function and on metal retention efficiency was also evaluated. The results revealed that system performance was dependent on material composition and particle size (smaller particle size being more effective). The highest metal removal efficiencies (Zn, Ni, Cd, Cu and Pb) and largest amount of water treated (per volume of material applied) were achieved by an aluminium oxide-based recycled mineral material (2–4 mm). While smaller-grained materials performed better in terms of removal efficiency, the removal rates achieved by coarser-grained, commercially available mineral product (5–15 mm) were comparable to those achieved by small-grained slag (2–4 mm). Full-scale systems using the recycled mineral product (2–4 mm) would have an approximately two-fold longer material replacement time than systems using the slag (2–4 mm). Replacement time for the larger-grained materials tested could not be determined, due to problems with freezing. Overall, the recycled mineral material tested can be recommended for full-scale tests, especially when high zinc removal rates are required. Highlights: In situ pilot-scale tests enabled good evaluation of filter materials. Smaller-grained materials were more effective in metal removal. An aluminium oxide-based recycled mineral filter achieved best metal removal.