Improving fault image by determination of optimum seismic survey parameters using ray-based modeling. (21st February 2018)

• Record Type: Journal Article
• Authors: Saffarzadeh, Sadegh; Javaherian, Abdolrahim; Hasani, Hossein; Talebi, Mohammad Ali
• Is Part Of: Journal of geophysics and engineering. Volume 15:Number 3(2018:Jun.)
• Page Start: 668
• Page End: 680
• Publication Date: 2018-02-21
• Subjects: ray tracing -- illumination map -- seismic survey modeling -- fault imaging; Geophysics -- Periodicals; Prospecting -- Geophysical methods -- Periodicals; Engineering -- Periodicals; 622.1505
• DOI: 10.1088/1742-2140/aaa044
• Languages: English
• ISSNs: 1742-2132

Abstract

Abstract: In complex structures such as faults, salt domes and reefs, specifying the survey parameters is more challenging and critical owing to the complicated wave field behavior involved in such structures. In the petroleum industry, detecting faults has become crucial for reservoir potential where faults can act as traps for hydrocarbon. In this regard, seismic survey modeling is employed to construct a model close to the real structure, and obtain very realistic synthetic seismic data. Seismic modeling software, the velocity model and parameters pre-determined by conventional methods enable a seismic survey designer to run a shot-by-shot virtual survey operation. A reliable velocity model of structures can be constructed by integrating the 2D seismic data, geological reports and the well information. The effects of various survey designs can be investigated by the analysis of illumination maps and flower plots. Also, seismic processing of the synthetic data output can describe the target image using different survey parameters. Therefore, seismic modeling is one of the most economical ways to establish and test the optimum acquisition parameters to obtain the best image when dealing with complex geological structures. The primary objective of this study is to design a proper 3D seismic survey orientation to achieve fault zone structures through ray-tracing seismic modeling. The results prove that a seismic survey designer can enhance the image of fault planes in a seismic section by utilizing the proposed modeling and processing approach.