MCNP Models for Tokamak Cooling Water System Equipment Evaluations. (18th August 2019)

• Record Type: Journal Article
• Authors: Radulescu, Georgeta; Royston, Katherine E.; Wilson, Stephen C.; Van Hove, Walter; Williamson, David E.; Kim, Seokho H.
• Is Part Of: Fusion science and technology. Volume 75:Number 6(2019)
• Page Start: 452
• Page End: 457
• Publication Date: 2019-08-18
• Subjects: ITER -- Tokamak cooling water system -- heat exchanger; Fusion reactors -- Periodicals; Nuclear fusion -- Periodicals; Fusion reactors; Nuclear fusion; Periodicals; 621.48405
• DOI: 10.1080/15361055.2019.1589205
• Languages: English
• ISSNs: 1536-1055

Abstract

Abstract: Heat generated in the ITER fusion reactor is deposited in the tokamak vacuum vessel, in-vessel components, and in the components of the neutral beam injector during plasma operations and during subsequent decay of activation products. This heat is managed by the tokamak cooling water system (TCWS). The stainless steel material in the integrated loop of blanket edge-localized mode vertical stabilization coils and divertor (IBED) components (e.g., piping, heat exchangers (HXs), and pumps) contains activation sources because of its exposure primarily to neutron radiation from the decay of 17 N, which is a short-lived radionuclide produced by neutron capture reactions with oxygen nuclei in the IBED primary heat transfer system (PHTS) cooling water during plasma operations. A detailed geometry model of the IBED stainless steel components and neutron radiation sources is required for an accurate assessment of the gamma activation sources on level 3 of the tokamak building. In the baseline design, each of the eight IBED PHTS cooling trains has two shell-and-tube heat exchangers (HXs) connected in series. Because these HXs are very large and contain a large amount of radioactive water, the possibility of using compact HXs of the welded shell-and-plate type is under investigation. This paper presents two Monte Carlo N-Particle (MCNP) TCWS geometry models, one model for each HX type, along with the associated piping. These models were obtained by automatic geometry conversion from TCWS computer-aided design models. The TCWS geometry models and neutron source definitions were incorporated into a baseline MCNP model of the Tokamak Complex.