Effect of Zn migration on the thermoelectric properties of Zn4Sb3 material. Issue 17 (1st December 2017)

• Record Type: Journal Article
• Authors: Yang, Jian; Zhang, Xiangzhao; Ge, Bangzhi; Yan, Junnan; Liu, Guiwu; Shi, Zhongqi; Qiao, Guanjun
• Is Part Of: Ceramics international. Volume 43:Issue 17(2017)
• Page Start: 15275
• Page End: 15280
• Publication Date: 2017-12-01
• Subjects: Zn migration -- Zinc antimonide -- Power factor -- Thermoelectric properties; Ceramics -- Periodicals; Céramique industrielle -- Périodiques; Ceramics; Periodicals; Electronic journals; 666
• DOI: 10.1016/j.ceramint.2017.08.065
• Languages: English
• ISSNs: 0272-8842

Abstract

Abstract: β-Zn4 Sb3 is interesting as thermoelectric material at moderate temperature due to the extreme low thermal conductivity. Recent success in energy band engineering or nano-engineering led to a significant improvement in the thermoelectric properties of β-Zn4 Sb3 . In this work, we utilize the direct current to drive the migration of Zn by designing of sintering mould. Obvious Zn migration under the direct current applied in the plasma activated sintering (PAS) process is found in Zn4 Sb3 compounds, and Zn exhibits significantly heterogeneous gradient composition distribution. At the top of sample, the single-phase Zn4 Sb3 decomposes into ZnSb phase because of the loss of Zn, while Zn originated from lattice and interstitial sites in Zn4 Sb3 is abundant in the bottom. The temperature-dependent transport measurements are also carried out at 323–673 K. Zn migration has a huge influence on the thermoelectric properties because of the sensitivity of Zn4 Sb3 . The maximum power factor can reach ~ 1.44 mW m −1 K −2 at 673 K due to the high Seebeck coefficient and low resistivity, which is one of the highest values in the reported results. The resulting peak ZT value of ~ 1.2 at 673 K is obtained. To control the Zn distribution by tuning the current is a feasible approach to improve the thermoelectric properties of Zn4 Sb3 material.