Controlling of ZnO nanostructures by solute concentration and its effect on growth, structural and optical properties. (27th October 2015)

• Record Type: Journal Article
• Authors: Kumar, Yogendra; Rana, Amit Kumar; Bhojane, Prateek; Pusty, Manojit; Bagwe, Vivas; Sen, Somaditya; Shirage, Parasharam M
• Is Part Of: Materials research express. Volume 2:Number 10(2015)
• Publication Date: 2015-10-27
• Subjects: ZnO-nanostructures -- wet chemical method -- concentration variation -- optical properties -- structural properties; Materials science -- Research -- Periodicals; Materials science -- Periodicals; 620.11
• DOI: 10.1088/2053-1591/2/10/105017
• Languages: English
• ISSNs: 2053-1591

Abstract

Abstract: ZnO nanostructured films were prepared by a chemical bath deposition method on glass substrates without any assistance of either microwave or high pressure autoclaves. The effect of solute concentration on the pure wurtzite ZnO nanostructure morphologies is studied. The control of the solute concentration helps to control the nanostructure to form nano-needles, and -rods. X-ray diffraction (XRD) studies revealed highly c -axis oriented thin films. Scanning electron microscopy (SEM) confirms the modification of the nanostructure dependent on the concentration. Transmission electron microscopy (TEM) results show the single crystalline electron diffraction pattern, indicating high quality nano-material. UV–vis results show the variation in the band gap from 3.20 eV to 3.14 eV with increasing concentration as the nanostructures change from needle- to rod-like. Photoluminescence (PL) data indicate the existence of defects in the nanomaterials emitting light in the yellow–green region, with broad UV and visible spectra. A sharp and strong peak is observed at ∼438 cm −1 by Raman spectroscopy, assigned to the optical mode of ZnO, the characteristic peak for the highly-crystalline wurtzite hexagonal phase. The solute concentration significantly affects the formation of defect states in the nanostructured films, and as a result, it alters the structural and optical properties. Current–voltage characteristics alter with the measurement environment, indicating potential sensor applications.