A novel approach to phase space reconstruction of single lead ECG for QRS complex detection. (January 2018)

• Record Type: Journal Article
• Authors: Li, Yanjun; Tang, Xiaoying; Xu, Zhi; Yan, Hong
• Is Part Of: Biomedical signal processing and control. Volume 39(2018)
• Page Start: 405
• Page End: 415
• Publication Date: 2018-01
• Subjects: ECG -- QRS complex detection -- Phase-space reconstruction -- Matched filtering -- MIT-BIH arrhythmia database -- MIT-BIH noise stress test database; Signal processing -- Periodicals; Biomedical engineering -- Periodicals; Signal Processing, Computer-Assisted -- Periodicals; Image Processing, Computer-Assisted -- Periodicals; Biomedical Engineering -- Periodicals; 610.28
• DOI: 10.1016/j.bspc.2017.06.007
• Languages: English
• ISSNs: 1746-8094

Abstract

Highlights: A novel approach to reconstructed phase space (RPS) of single lead ECG is proposed for QRS complex detection. Traditional two-dimensional RPS ( x ( t ), x ( t + τ)) is improved as three-dimensional coordinate ( x, y, t ). The third parameter t is an indispensable time index to locate the position of QRS complex. The algorithm was tested on three public benchmark databases, including the MIT-BIH Arrhythmia Database, the Long-term ST Database and the MIT-BIH Noise Stress Test Database. The proposed algorithm achieved better performance on QRS complex detection when in comparison with the state-of-the-art methods. Abstract: Two-dimensional reconstructed phase space (RPS) of single lead Electrocardiogram (ECG) is usually implemented by plotting the ECG amplitude x ( t + τ) versus x ( t ) into the two-dimensional coordinate system, where the value of time delay τ determined the morphology of the reconstructed trajectory. However, the value of τ is very difficult to select because different theories derived different τ. In this paper, a novel approach to phase space reconstruction of single lead ECG without using τ is proposed. The first two coordinates ( x, y ) from ( x, y, t ) were projected into the x - y coordinate system, where x is the amplitude of the ECG and y is the first order difference of x . Besides, time t is corresponding to the sampling time moment. As QRS complex is usually the most striking waveform that dominant with the highest amplitude or the highest slope, the largest semi-circle in the RPS is usually derived from QRS complex. The location of QRS complex in the original ECG is determined by the time coordinate t that corresponds to the largest semi-circle in the x - y coordinate system. The algorithm was developed at the MIT-BIH Arrhythmia Database (109494 beats within 24 h in total) and was tested on the Long-term ST Database (8897780 beats within 1991.8 h in total). The accuracy (ACC), the sensitivity (SEN) and the positive predictivity value (PPV) for the MIT-BIH Arrhythmia Database were 99.81%, 99.87% and 99.93%, respectively; while the corresponding values for the Long-term ST Database were 99.87%, 99.96% and 99.91%, respectively. Meanwhile, the consuming time was only 6.73 ms for processing 6 s' ECG data. Furthermore, the anti-noise ability of the proposed method was tested on the MIT-BIH Noise Stress Test Database (4265 beats in total at each noise level for one lead ECG). Both ACC and PPV were higher than 85% and the SEN was higher than 99% even when the signal-to-noise ratio (SNR) was as low as 0 dB. In conclusion, the proposed algorithm achieves better performance on QRS complex detection when in comparison with the state-of-the-art methods, and it is suited for the detection of QRS complex in the ECG associated with poor signal quality and severe arrhythmia.