Dynamic strength of single lap joints with similar and dissimilar adherends. (January 2015)

• Record Type: Journal Article
• Authors: Sankar, H. Ravi; Adamvalli, M.; Kulkarni, Prasad P.; Parameswaran, Venkitanarayanan
• Is Part Of: International journal of adhesion & adhesives. Volume 56(2015)
• Page Start: 46
• Page End: 52
• Publication Date: 2015-01
• Subjects: Epoxy -- Metals -- Lap-shear -- Impact; Adhesion -- Periodicals; Adhesives -- Periodicals; Adhésion (Physique) -- Périodiques; Adhésifs -- Périodiques; Adhesie; Kleefstoffen; Adhesion; Adhesives; Periodicals; 668.3
• DOI: 10.1016/j.ijadhadh.2014.07.014
• Languages: English
• ISSNs: 0143-7496

Abstract

Abstract: The increased use of adhesives for joining structural parts demands a thorough understanding of their load carrying capacity. The strength of the adhesive joints depends on several factors such as the joint geometry, adhesive type, adherend properties and also on the loading conditions. Particularly polymer based adhesives exhibit sensitivity to loading rate and therefore it is important to understand their behavior under impact like situations. The effect of similar versus dissimilar adherends on the dynamic strength of adhesive lap joints is addressed in this study. The dynamic strength is evaluated using the split-cylinder lap joint geometry in a split Hopkinson pressure bar setup. The commercial adhesive Araldite 2014 is used for preparing the joints. The adherend materials considered included steel and aluminum. The results of the study indicated that the dynamic strength of the lap joint is influenced by the adherend material and also by the adherent combination. Even in the case of joints with similar adherends, the strength was affected by the adherend type. The strength of steel–steel joints was higher than that for aluminum–aluminum joints. In the case of dissimilar adherends, the strength was lower than that of the case of similar adherends. The results of this study indicate that the combination of adherend material should also be accounted for while designing lap joints.