Measurement and optimisation of residual tensile strength and delamination damage of drilled flax fibre reinforced composites. (November 2015)

• Record Type: Journal Article
• Authors: Abdul Nasir, A.A.; Azmi, A.I.; Khalil, A.N.M.
• Is Part Of: Measurement. Volume 75(2015:Nov.)
• Page Start: 298
• Page End: 307
• Publication Date: 2015-11
• Subjects: Fibres (flax natural fibres) -- Residual strength -- Mechanical/tensile testing -- Machining (drilling); Weights and measures -- Periodicals; Measurement -- Periodicals; Measurement; Weights and measures; Periodicals; 530.8
• DOI: 10.1016/j.measurement.2015.07.046
• Languages: English
• ISSNs: 0263-2241

Abstract

Graphical abstract: Photograph of 8 mm hole size tensile damage samples after drilling operation. Highlights: Flax fibre epoxy composites are fabricated using resin infusion process. Residual tensile strength and delamination damage of flax fibre composites are experimentally measured and investigated. Experimental design approach is used to determine the residual tensile strength and delamination damage. Feed rate has the significant effect on the residual tensile strength as well as delamination damage. Abstract: The advent of natural fibre as reinforcement material for polymer composites has gained much attention in recent years. Since composite materials made of natural fibres exhibited good and comparable mechanical properties, they are being applied in automotive, packaging and general appliances. These applications would inevitably require the natural fibre composites to be drilled, if not machined. However, open hole in the composites induces discontinuity and strength reduction in the composite structure. Results from literature search showed that experimental study on evaluating the effect of hole on the drilled natural fibre composites, namely, flax fibre, has not been attempted or reported. Therefore, the objective of this study is to experimentally evaluate and measure the residual tensile strength and delamination factor of the drilled flax fibre composites. In particular, a series of drilling experiments were performed for collection and measurement of the aforementioned outputs through Taguchi design of experiment. The results suggest that both residual strength and delamination factor were more sensitive to the change in feed rate, followed by spindle speed and tool geometry. Indication from this study is that flax fibre composites could be a potential substitute of their synthetic fibres counterpart in the load-bearing as well as non-structural applications.