Experimental study on the impact of reactant gas pressure in the conversion of coal char to combustible gas products in the context of Underground Coal Gasification. (1st November 2015)

• Record Type: Journal Article
• Authors: Konstantinou, Eleni; Marsh, Richard
• Is Part Of: Fuel. Volume 159(2015)
• Page Start: 508
• Page End: 518
• Publication Date: 2015-11-01
• Subjects: UCG -- Underground Coal Gasification -- High pressure -- Carbon dioxide–steam gasification -- Coal char; Fuel -- Periodicals; Coal -- Periodicals; Coal; Fuel; Periodicals; 662.6
• DOI: 10.1016/j.fuel.2015.06.097
• Languages: English
• ISSNs: 0016-2361

Abstract

Highlights: Optimum gasification conditions were determined for the bituminous coal. Pressure enhances the gasification rate and hence the gasification efficiency. There is an optimum operation pressure which produces the best heating value of the product gas. Carbon conversion does not seem to be affected significantly by the type of coal. The shrinking core model predicts fairly well the reaction of char with CO2 and steam at 0.1 MPa. Abstract: This paper describes an experimental investigation to determine the impact of pressurised reactor conditions within the reduction zone of a gasification process employing a semi-batch reactor with a bituminous coal. The conditions examined with this bespoke pressurised rig were designed to be representative of an Underground Coal Gasification (UCG) process, at pressures up to 3.0 MPa and temperatures up to 900 °C; coal samples were approximately 36 g per test. Current published literature suggests that one of the key controlling factors in the conversion and yield within such processes is the behaviour of the pyrolysed coal (char) in the reduction zone of the UCG cavity. This was achieved by using carbon dioxide and steam as the primary reductants with char derived from bituminous coal at a variety of pressure and temperature levels, plus at a range of relative H2 O/CO2 proportions. The composition of the resulting product gas was measured and subsequently used to calculate cold gas efficiency and carbon conversion (during 90 min at steady state). A shrinking core model was then employed to determine the activation energy and pre-exponential factor under these conditions. The results were then used to extrapolate the contribution of the reduction zone in published research including UCG field trials where discrete analysis of the zones within the gasification cavity was not possible. It was shown that pressure increases the reduction–gasification process of the char in terms of carbon conversion, cold gas efficiency and heating value of the product gas. Under the conditions evaluated herein, optimum gasification conditions for the bituminous coal were determined as 1.65 MPa at H2 O/CO2 ratio of 2:1 by mass at 900 °C which produced a syngas with a composition of 17.4% CO, 3% CH4, 42.1% H2 and LHV of 7.8 MJ/N m 3 .