Band Engineering via Sn‐doping of Zinc Oxide Electron Transport Materials for Perovskite Solar Cells. Issue 2 (9th January 2018)

• Record Type: Journal Article
• Authors: Su, Tongyu; Zheng, Yuanhui; Ma, Zongwei; Cheng, Long; Xu, Xueli; Zhang, Fapei; Yu, Gui; Sheng, Zhigao
• Is Part Of: ChemistrySelect. Volume 3:Issue 2(2018)
• Page Start: 363
• Page End: 367
• Publication Date: 2018-01-09
• Subjects: band engineering -- electron transport materials -- perovskite solar cells -- Sn-doping -- work function; Chemistry -- Periodicals; 540.5
• DOI: 10.1002/slct.201702419
• Languages: English
• ISSNs: 2365-6549

Abstract

Abstract: The performance of planar perovskite solar cells (PSCs) is quite dependent on the interfacial conditions and then the interfacial band engineering is very important not only for the effective improvement of power conversion efficiency (PCE) but also for the better understanding of the charge transfer in the cells. In this report, the band engineering of the ZnO based electron transport layer (ETL) in PSCs was studied by modulating Sn‐doping level (0 ≤ x ≤ 0.2). A V ‐like variation of work function ( W f ) as function of Sn‐doping level in Zn1‐ x Sn x O1+ x films was realized from 4.23 to 4.39 eV. As a result, the photovoltaic performance of PSCs with the Zn1‐ x Sn x O1+ x ETLs was adjusted and the V ‐like tendencies of photovoltaic parameters of devices, such as open‐circuit voltage ( V OC ) and the short‐circuit current ( J SC ), were found. The maximum values of V OC and J SC were achieved as 1.04 V and 20.68 mA cm −2 with an ETL of Zn1‐ x Sn x O1+ x, respectively, which corresponds to a highest PCE of 14.12% for ZnO‐based pervoskite solar cells with a large fill factor of 65.62. Abstract : The band alignment at the Zn1‐ x Sn x O1+ x / perovskite interface in the solar cell was tuned by Sn‐doping level.