Analogue experimental study on centrifugal-air blast granulation for molten slag. (5th September 2015)

• Record Type: Journal Article
• Authors: Zhu, Xun; Zhang, Hui; Tan, Yu; Wang, Hong; Liao, Qiang
• Is Part Of: Applied thermal engineering. Volume 88(2015:Sep.)
• Page Start: 157
• Page End: 164
• Publication Date: 2015-09-05
• Subjects: Molten slag -- Centrifugal granulation -- Air blast -- Particle -- Fiber; Heat engineering -- Periodicals; Heating -- Equipment and supplies -- Periodicals; Periodicals; 621.40205
• DOI: 10.1016/j.applthermaleng.2014.11.077
• Languages: English
• ISSNs: 1359-4311

Abstract

Abstract: Blast furnace slag is a by-product in iron and steel production process which has a high yield with extremely high discharge temperature. Aiming at energy and water saving as well as emission reduction, dry granulation technique appears to be a good application for the treatment of blast furnace slag. In this study, a granulation technique combining a high-speed rotating cup with air blast is proposed. The performance of this design was investigated by adopting a mixture of rosin and paraffin wax as the analogue of blast furnace slag. The effects of rotating speed of the atomizer, liquid flow rate and blast air flow rate on particle size, particle mass distribution and fiber mass fraction were studied. The effect of the function of air blast on the granulation performance was particularly discussed. The results showed that at a higher rotating speed and a smaller liquid flow rate, smaller particles can be easily obtained, yet the fiber mass fraction also increases. However, the increasing blast air leads to the increase of particle size and fiber mass fraction. For the operating conditions tested in this study, over 60% of total mass of particles fall within the size range of 0.5–1 mm, which means that the present system has a good performance in centrifugal granulation.