Surface characteristics and erosion phenomena in WEDM of alumina composites. Issue 16 (10th December 2018)

• Record Type: Journal Article
• Authors: Singh, Meinam Annebushan; Sarma, Deba Kumar; Hanzel, Ondrej; Sedláček, Jaroslav; Šajgalík, Pavol
• Is Part Of: Materials and manufacturing processes. Volume 33:Issue 16(2018)
• Page Start: 1815
• Page End: 1821
• Publication Date: 2018-12-10
• Subjects: Alumina -- MWCNT -- erosion -- WEDM -- porosity -- cracks -- subsurface -- spalling; Manufacturing processes -- Periodicals; Materials -- Periodicals; Manufactured Materials; 670.5
• DOI: 10.1080/10426914.2018.1512127
• Languages: English
• ISSNs: 1042-6914

Abstract

ABSTRACT: Reinforcing the ceramic materials with a conducting filler allows the net electrical properties to increase. This makes the composites machinable by electrical discharge process. Present work identifies the influence of multi-walled carbon nanotubes (MWCNT) as conducting fillers toward the machined surface profile. Alumina composites with 5 and 10 vol. % MWCNTs are fabricated and machined by wire electrical discharge machining process. The spalling effect is found to be more dominant at lower MWCNT concentrations in the composites. Cracks, porosity, and oxidization of the surface materials are the main defects observed during the machining process. Also, a more intense cracks and porous behavior is observed at lower concentration of MWCNT (5 vol. %). A closer analysis of machined surface edges yielded some phenomena of mechanical erosion and chipping due to physical contact. This situation is brought forward by low electrical conductivity and high brittleness of the composites. The Energy Dispersive X-Ray (EDX) analysis confers toward actual dissociation and melting of the carbon nanotubes even at low concentration of MWCNTs (5 vol. %) though not readily visible.