Microstructure and mechanical properties of hot wire laser clad layers for repairing precipitation hardening martensitic stainless steel. (December 2015)

• Record Type: Journal Article
• Authors: Wen, Peng; Cai, Zhipeng; Feng, Zhenhua; Wang, Gang
• Is Part Of: Optics & laser technology. Volume 75(2015)
• Page Start: 207
• Page End: 213
• Publication Date: 2015-12
• Subjects: Hot wire laser cladding -- Laser scanning -- Martensitic stainless steel -- Microstructure -- Properties; Optics -- Periodicals; Lasers -- Periodicals; Electronic journals; 621.366
• DOI: 10.1016/j.optlastec.2015.07.014
• Languages: English
• ISSNs: 0030-3992

Abstract

Abstract: Precipitation hardening martensitic stainless steel (PH-MSS) is widely used as load-bearing parts because of its excellent overall properties. It is economical and flexible to repair the failure parts instead of changing new ones. However, it is difficult to keep properties of repaired part as good as those of the substrate. With preheating wire by resistance heat, hot wire laser cladding owns both merits of low heat input and high deposition efficiency, thus is regarded as an advantaged repairing technology for damaged parts of high value. Multi-pass layers were cladded on the surface of FV520B by hot wire laser cladding. The microstructure and mechanical properties were compared and analyzed for the substrate and the clad layer. For the as-cladded layer, microstructure was found non-uniform and divided into quenched and tempered regions. Tensile strength was almost equivalent to that of the substrate, while ductility and impact toughness deteriorated much. With using laser scanning layer by layer during laser cladding, microstructure of the clad layers was tempered to fine martensite uniformly. The ductility and toughness of the clad layer were improved to be equivalent to those of the substrate, while the tensile strength was a little lower than that of the substrate. By adding TiC nanoparticles as well as laser scanning, the precipitation strengthening effect was improved and the structure was refined in the clad layer. The strength, ductility and toughness were all improved further. Finally, high quality clad layers were obtained with equivalent or even superior mechanical properties to the substrate, offering a valuable technique to repair PH-MSS. Highlights: Non-uniform microstructure deteriorated mechanical properties of as-cladded layers. Microstructure got tempered by laser scanning. Nanoparticle addition strengthened precipitation hardening effect. High quality cladded layer was obtained by laser hot wire cladding without post-weld heat treatment.