Optimisation and finite element simulation of the chopping process for chopper sugarcane harvesting. (November 2018) - Xie, Luxin
Abstract : High levels of mechanical damage are a major obstacle for the mechanical harvesting of sugarcane. A chopping system for use in a sugarcane harvester was developed and tested. The three influencing factors studied were the rotational speed of chopping drums ( RS ), the overlapping length of upper and lower chopping blades ( OL ) and the bevel angle ( BA ). The quality of chopping included the percentage of undamaged billets ( PUB ) and the standard deviation of chopping length ( SDCL ), and together with the average maximum chopping power consumption ( PC ) these were regarded as outputs. A Box-Behnken design was employed to conduct the experiments and build regression models. The optimised results indicated that when RS increased from 200 to 250 rpm on the condition that OL and BA were set as 2 mm and 21.8°, respectively, PUB decreased from 97.0% to 95.6%, with PC increasing from 515 to 625 W and SDCL increasing from 1.24 to 1.36 mm. Based on these optimised parameters, a finite element model was established to simulate the chopping process. The chopping resistance of blades, stress distribution of sugarcane and blades in the chopping process were then analysed. Results showed that the maximum Von Mises stress of sugarcane, upper and lower chopping blades in the chopping process were about 16.87, 106.08 and 115.72 MPa, respectively. Highlights: A sugarcane chopping system was developed to improve chopping performance. Box-Behnken design was used to optimise sugarcane chopping quality. FEM can be used to assist understanding of sugarcane chopping process. High sugarcane conveying speed results in more stalk damage.