Gafchromic EBT3 film dosimetry in electron beams — energy dependence and improved film read‐out. (8th January 2016)

• Record Type: Journal Article
• Authors: Sipilä, Petri; Ojala, Jarkko; Kaijaluoto, Sampsa; Jokelainen, Ilkka; Kosunen, Antti
• Is Part Of: Journal of applied clinical medical physics. Volume 17:Number 1(2016)
• Page Start: 360
• Page End: 373
• Publication Date: 2016-01-08
• Subjects: dosimetry -- radiochromic film -- Gafchromic -- EBT3 -- Monte Carlo; Medical physics -- Periodicals; Clinical medicine -- Periodicals; Health Physics; Clinical Medicine; Electronic journals; Periodicals; Periodicals; Fulltext; Internet Resources; 610.153
• DOI: 10.1120/jacmp.v17i1.5970
• Languages: English
• ISSNs: 1526-9914

Abstract

Abstract : For megavoltage photon radiation, the fundamental dosimetry characteristics of Gafchromic EBT3 film were determined in 60 Co gamma ray beam with addition of experimental and Monte Carlo (MC)‐simulated energy dependence of the film for 6 MV photon beam and 6 MeV, 9 MeV, 12 MeV, and 16 MeV electron beams in water phantom. For the film read‐out, two phase correction of scanner sensitivity was applied: a matrix correction for scanning area and dose‐dependent correction by iterative procedure. With these corrections, the uniformity of response can be improved to be within ± 50 pixel values (PVs). To improve the read‐out accuracy, a procedure with flipped film orientations was established. With the method, scanner uniformity can be improved further and dust particles, scratches and/or dirt on scanner glass can be detected and eliminated. Responses from red and green channels were averaged for read‐out, which decreased the effect of noise present in values from separate channels. Since the signal level with the blue channel is considerably lower than with other channels, the signal variation due to different perturbation effects increases the noise level so that the blue channel is not recommended to be used for dose determination. However, the blue channel can be used for the detection of emulsion thickness variations for film quality evaluations with unexposed films. With electron beams ranging from 6 MeV to 16 MeV and at reference measurement conditions in water, the energy dependence of the EBT3 film is uniform within 0.5%, with uncertainties close to 1.6% ( k = 2 ) . Including 6 MV photon beam and the electron beams mentioned, the energy dependence is within 1.1%. No notable differences were found between the experimental and MC‐simulated responses, indicating negligible change in intrinsic energy dependence of the EBT3 film for 6 MV photon beam and 6 MeV–16 MeV electron beams. Based on the dosimetric characteristics of the EBT3 film, the read‐out procedure established, the nearly uniform energy dependence found and the estimated uncertainties, the EBT3 film was concluded to be a suitable 2D dosimeter for measuring electron or mixed photon/electron dose distributions in water phantom. Uncertainties of 3.7% ( k = 2 ) for absolute and 2.3% ( k = 2 ) for relative dose were estimated. PACS numbers: 87.53.Bn, 87.55.K‐, 87.55.Qr