Functionalization of SLS parts for application as SERS substrates in chemical analysis: Preliminary results. Issue 4 (10th June 2014)

• Record Type: Journal Article
• Authors: de Oliveira Setti, Grazielle; Fernandes de Oliveira, Marcelo; Alves Maia, Izaque; Vicente Lopes da Silva, Jorge; Joanni, Ednan
• Is Part Of: Rapid prototyping journal. Volume 20:Issue 4(2014)
• Page Start: 280
• Page End: 284
• Publication Date: 2014-06-10
• Subjects: Polymers -- Selective laser sintering -- Zinc oxide -- Hydrothermal synthesis -- SERS; Engineering design -- Periodicals; 620.004205
• DOI: 10.1108/RPJ-08-2012-0071
• Languages: English
• ISSNs: 1355-2546

Abstract

Abstract : Purpose: – This paper aims to demonstrate the functionalization of polyamide parts made by selective laser sintering (SLS) for application as substrates for chemical analysis by surface-enhanced Raman scattering (SERS). Design/methodology/approach: – Fabrication of Nylon 12 (Duraform PA®) samples using two laser power levels and deposition of a layer of gold-coated zinc oxide nanostructures. Performance of these substrates in the detection of a known compound was tested by Raman spectroscopy. Findings: – The hydrothermal synthesis proved to be a good method for functionalizing the surface of polyamide parts made by the SLS process. By varying the synthesis temperature, ZnO nanoparticles and nanorods attached to the sample surfaces could be obtained. The degree of sample sintering had an effect on the growth of the nanostructures. The gold-coated functionalized surfaces enhanced the Raman signal from crystal violet by more than three orders of magnitude. ZnO nanorods grown on well-sintered SLS parts showed the best performance from the set of samples tested in this work. Originality/value: – ZnO nanostructures were grown directly on untreated surfaces of SLS-made polyamide. These substrates were used for chemical analysis by SERS.