Exploration of specimen geometry and tab configuration for tensile testing exploiting the potential of 3D printing freeform shape continuous carbon fibre-reinforced nylon matrix composites. (October 2018)

• Record Type: Journal Article
• Authors: Pyl, Lincy; Kalteremidou, Kalliopi-Artemi; Van Hemelrijck, Danny
• Is Part Of: Polymer testing. Volume 71(2018)
• Page Start: 318
• Page End: 328
• Publication Date: 2018-10
• Subjects: 3D printed polymer-matrix composites -- Tensile properties -- Design of test specimens -- Experimental investigation; Polymers -- Testing -- Periodicals; Polymères -- Tests -- Périodiques; 620.1920287
• DOI: 10.1016/j.polymertesting.2018.09.022
• Languages: English
• ISSNs: 0142-9418

Abstract

Abstract: Now that the design freedom of printing of continuous fibre-reinforced polymers has become available, the recommendations on the specimens' geometry and tab configuration to experimentally determine the elastic properties of conventionally manufactured composites are reviewed. To explore this design freedom, tensile tests for five types of specimen geometry and tabs were investigated. Continuous carbon fibre-reinforced Nylon specimens were printed using a Mark Two commercial 3D printer. Dumbbell shape specimens according to ASTM D638-14 with proposed radius dimension, 76 mm, and with enlarged radius, 244 mm to reduce stress concentrations at the fillet and avoid crack initiation were tested. Rectangular specimens according to ASTM D3039/3039M-14 outperform other specimen geometries. The effectiveness of printed end tabs was investigated. Even although 3D printing offers facilities for printing end tabs, there is no convincing evidence that the performance of specimen gripping is better and the printing is more time consuming and expensive. Rectangular specimens with paper end tabs work best and that is why they were used in the further characterization. The effect of alternating Nylon layers was also investigated and shows drastic reduction in stiffness. In a next step, the tensile properties of a set of eight rectangular specimens with 0° unidirectional layup were characterized and compared with conventionally manufactured composites. The tensile properties for different fibre orientations were also determined. The effect of fibre location and microstructure was studied bringing important insights to the promising 3D printing but also revealing challenges to overcome (e.g. inhomogeneity in fibre distribution) to be able to fully explore the design freedom. Highlights: Optimal specimens' design for tensile testing of 3D printed carbon fibre-reinforced polymers. Tensile performance of 0° unidirectional 3D printed carbon fibre-reinforced Nylon matrix polymers. Influence of alternating Nylon layers between fibre layers. Tensile properties for 0/90°, ±45°, quasi-isotropic and 90° layups and comparison with conventionally manufactured composites.