Tensile strengths of polyamide based 3D printed polymers in liquid nitrogen. Issue 1 (November 2015)

• Record Type: Journal Article
• Authors: Cruz, P; Shoemake, E D; Adam, P; Leachman, J
• Is Part Of: IOP conference series. Volume 102:Issue 1(2015)
• Publication Date: 2015-11
• Subjects: Materials science -- Periodicals; 620.1105
• DOI: 10.1088/1757-899X/102/1/012020
• Languages: English
• ISSNs: 1757-8981

Abstract

Abstract: Advances in additive manufacturing technology have made 3D printing a viable solution for many industries, allowing for the manufacture of designs that could not be made through traditional subtractive methods. Applicability of additive manufacturing in cryogenic applications is hindered, however, by a lack of accurate material properties information. Nylon is available for printing using fused deposition modeling (FDM) and selective laser sintering (SLS). We selected 5 SLS (DuraForm® EX, DuraForm® HST, DuraForm® PA, PA 640-GSL, and PA 840-GSL) and 2 FDM (Nylon 12, ULTEM) nylon variants based on the bulk material properties and printed properties at room temperature. Tensile tests were performed on five samples of each material while immersed in liquid nitrogen at approximately 77 Kelvin. Samples were tested in XY and, where available, Z printing directions to determine influence on material properties. Results show typical SLS and FDM nylon ultimate strength retention at 77 K, when compared to (extruded or molded) nylon ultimate strength.