Interlayer diffusion of surface segregating additives to improve the isotropy of fused deposition modeling products. (12th September 2018)

• Record Type: Journal Article
• Authors: Levenhagen, Neiko P.; Dadmun, Mark D.
• Is Part Of: Polymer. Volume 152(2018)
• Page Start: 35
• Page End: 41
• Publication Date: 2018-09-12
• Subjects: 3D printing -- Additive manufacturing -- Isotropy -- Star architectures; Polymers -- Periodicals; Polymerization -- Periodicals; Polymères -- Périodiques; Polymérisation -- Périodiques; 547.7
• DOI: 10.1016/j.polymer.2018.01.031
• Languages: English
• ISSNs: 0032-3861

Abstract

Abstract: It is well known that 3D printed parts prepared by fused deposition modeling (FDM) exhibit large anisotropy of mechanical properties. For instance, the mechanical properties observed of samples printed orthogonal to the print bed (transverse) are significantly weaker than those printed parallel to the bed (longitudinal). This behavior is a result of poor interlayer adhesion from limited diffusion and entanglement of chains across the interlayer interface. To improve the diffusion and entanglement of adjacent layers, our group has implemented a process in which bimodal blends comprised of a parent, high molecular weight polymer blended with an identical but low molecular weight (LMW) polymer is utilized. These bimodal blends lead to significant enhancements in the mechanical properties of samples printed in the transverse orientation. Additionally, the moduli, regardless of print orientation, become nearly identical, indicating a more isotropic part. To more fully understand this behavior, we report the impact of LMW architectures on the improvement of structural properties of 3D printed parts. The decrease in anisotropy of mechanical properties of PLA bimodal blends containing 2-arm (linear), 3-arm and 4-arm PLA stars (Mw of arm- ∼11 k) at loadings of 3, 10, and 15 mol% are tested under the same protocol as previous linear specimens. With the addition of just 3 mol% of each LMW additive, i ncreases in the maximum stress from 15% to 100% are observed for samples printed in the transverse orientation. A significant improvement in layer adhesion and a significantly more isotropic part is thus realized, where the 3-arm star exhibits optimal performance. Interpretation of the data presented leads to the conclusion that this is true because the 3-arm star most efficiently diffuses to the inter-filament interface and entangles with the linear polymer. Graphical abstract: Highlights: Methods to decrease structural anisotropy in 3D printed samples are presented. Low Molecular Weight (LMW) additives fortify interfaces and reduce anisotropy. Architecture of LMW additive impacts the structural properties of sample. 3-arm star offers optimal property improvement among LMW architectures studied.