Evolution of residual stress in Ti–Al–Ta–N coatings on hard metal milling inserts. (September 2015)

• Record Type: Journal Article
• Authors: Teppernegg, T.; Angerer, P.; Klünsner, T.; Tritremmel, C.; Czettl, C.
• Is Part Of: International journal of refractory metals & hard materials. Volume 52(2015:Sep.)
• Page Start: 171
• Page End: 175
• Publication Date: 2015-09
• Subjects: Ti–Al–N -- Thermal fatigue -- Wear -- X-ray diffraction -- Residual stress -- Elastic constants -- Milling tools; Heat resistant alloys -- Periodicals; Refractory materials -- Periodicals; Metallography -- Periodicals; Alliages réfractaires -- Périodiques; Matériaux réfractaires -- Périodiques; Métallographie -- Périodiques; Heat resistant alloys; Metallography; Refractory materials; Periodicals; Electronic journals; 669.73
• DOI: 10.1016/j.ijrmhm.2015.06.013
• Languages: English
• ISSNs: 0263-4368

Abstract

Abstract: Coated WC–Co hard metal milling inserts applied in milling application show thermal fatigue induced by interrupted tool-workpiece contact and wear as the two main damage mechanisms. Depending on the magnitudes of thermal and mechanical loads, either wear or thermal fatigue in form of combcracks may be dominant and determine the insert's lifetime. The present work illustrates the evolution of residual stress in an arc-evaporated Ti–Al–Ta–N coating for two different milling test setups, in one of which wear acted as the dominant damage mechanism. In the other test setup thermal fatigue fostered the formation of combcracks. Earlier work revealed a location on the tool's rake face, referred to as region of interest, with a significant buildup of tensile residual stresses in the WC phase of the substrate using synchrotron facilities. The residual stress state in the coating was determined in this region of interest by a cover method on the tools' rake faces after a defined number of cuts by X-ray diffraction using in-house facilities. In the wear dominated test setup, compressive residual stresses remained present until the end of tool life in coatings. Tensile residual stresses were found in coatings on inserts in which thermal fatigue was dominant. Highlights: Position resolved residual stress determination in TiAlTaN coatings of used milling inserts. Two test setups used to generate wear or thermal fatigue as dominant damage mechanism. No change of compressive residual stress state during tool life in wear dominated setup. Localized tensile residual stress build-up at early stages of application in other setup. Residual stress expressed in units of X-ray elastic constants.