A comparison of sliding mode and FRF-based observers for cylinder pressure estimation of spark ignition engine. (February 2017)

• Record Type: Journal Article
• Authors: Ali, Syed Abbas; Saraswati, Samir
• Is Part Of: Transactions of the Institute of Measurement and Control. Volume 39:Number 2(2017)
• Page Start: 163
• Page End: 172
• Publication Date: 2017-02
• Subjects: Cylinder pressure -- frequency response function -- sliding mode observer; Automatic control -- Periodicals; Measuring instruments -- Periodicals; Commande automatique -- Périodiques; Mesure -- Instruments -- Périodiques; 681.2
• DOI: 10.1177/0142331215604895
• Languages: English
• ISSNs: 0142-3312

Abstract

A sliding mode observer (SMO) is proposed for the estimation of cylinder pressure using crankshaft speed fluctuations. SMO parameters are updated using the difference between measured and observed crankshaft speed. The governing equations of cylinder pressure and crankshaft speed are described by a one-zone combustion model and crankshaft model dynamics, respectively. The observer is found to be unstable at top dead centre (TDC) due to zero combustion torque at this point. To prevent instability, observer gains are switched off near TDC and observer performance depends only on the modelling accuracies of the combustion model. This model is further improved by modelling flame development angleθ d and rapid burning angleθ b as a function of spark advance, equivalence ratio, mean speed and manifold pressure. Experimental investigations are carried out to test and validate the model on a spark ignition engine coupled with a dynamometer. The results of the SMO are compared with cylinder pressure profile estimated using a frequency response function (FRF). It is seen that the averaged relative error, using SMO, is reduced for all the test conditions in comparison with cylinder pressure estimation using FRF. This reduction in averaged relative error is more significant at the low-load, high-speed conditions where cycle-by-cycle variations are quite high.