Observation of self-magnetic field relaxations in Bi2223 and Y123 HTS tapes after over-current pulse and DC current operation. (July 2016)

• Record Type: Journal Article
• Authors: Tallouli, M.; Sun, J.; Chikumoto, N.; Otabe, E.S.; Shyshkin, O.; Charfi-Kaddour, S.; Yamaguchi, S.
• Is Part Of: Cryogenics. Volume 77(2016)
• Page Start: 53
• Page End: 58
• Publication Date: 2016-07
• Subjects: BSCCO tape -- YBCO tape -- Over-current pulse -- Current density profile -- Hall probe measurement -- Magnetic relaxation; Low temperature engineering -- Periodicals; Low temperature research -- Periodicals; 536.56
• DOI: 10.1016/j.cryogenics.2016.04.010
• Languages: English
• ISSNs: 0011-2275

Abstract

Highlights: An over current pulse for some milliseconds and DC current is applied to BSCCO and YBCO tapes. Hall probe measures self-magnetic field near the tapes' edge and scans the self-magnetic profiles. Linear equations of the inverse problem are calculated and current density profiles are shown. Over-current pulse and normal operations are compared. Change of the self-magnetic fields and current loop in HTS tapes are observed. Abstract: The development of power transmission lines based on long-length HTS tapes requires the production of high quality tapes. Due to fault conditions, technical mistakes and human errors during the operation of a DC power transmission line, an over-current pulse, several times larger than the rated current, could occur. To study the effect of such over-current pulses on the transport current density distribution in the HTS tapes, we simulated two start-up scenarios for one BSCCO and two YBCO tapes. The first start-up scenario is an initial over-current pulse during which the transport current was turned on rapidly, rising to 900 A during the first milliseconds, then reduced to a 100 A DC current. The second start-up scenario is normal operation, and involved increasing the transport current slowly from 0 A to 100 A at a rate of 1 A/s. For both scenarios, we then measured the vertical component of the self-magnetic field by means of a Hall probe above the tape, and afterward, by solving a linear equation of the inverse problem we obtain the current density profiles. We observe a change of the self-magnetic field above the edge of the BSCCO and YBCO tapes during 30 min after the 5 ms of over-current pulse and during the normal operation. The current density profiles are peaked in the centre for over-current pulse, and more peaked around the edge of the HTS tape for normal operation, which means that the limited time over-current pulse changes the current density profiles of the HTS tapes. We observe also a loop of current for YBCO tapes and we show the role of the HTS tape stabilizer.