Micromechanics of plastic deformation and phase transformation in a three-phase TRIP-assisted advanced high strength steel: Experiments and modeling. (May 2015)

• Record Type: Journal Article
• Authors: Srivastava, Ankit; Ghassemi-Armaki, Hassan; Sung, Hyokyung; Chen, Peng; Kumar, Sharvan; Bower, Allan F.
• Is Part Of: Journal of the mechanics and physics of solids. Volume 78(2015:May)
• Page Start: 46
• Page End: 69
• Publication Date: 2015-05
• Subjects: TRIP-assisted multiphase steel -- Mechanical testing -- Microstructures -- Crystal plasticity -- Finite elements; Mechanics, Applied -- Periodicals; Solids -- Periodicals; Mechanics -- Periodicals; Mécanique appliquée -- Périodiques; Solides -- Périodiques; Mechanics, Applied; Solids; Periodicals; 531.05
• DOI: 10.1016/j.jmps.2015.01.014
• Languages: English
• ISSNs: 0022-5096

Abstract

Abstract: The micromechanics of plastic deformation and phase transformation in a three-phase advanced high strength steel are analyzed both experimentally and by microstructure-based simulations. The steel examined is a three-phase (ferrite, martensite and retained austenite) quenched and partitioned sheet steel with a tensile strength of ~980 MPa. The macroscopic flow behavior and the volume fraction of martensite resulting from the austenite–martensite transformation during deformation were measured. In addition, micropillar compression specimens were extracted from the individual ferrite grains and the martensite particles, and using a flat-punch nanoindenter, stress–strain curves were obtained. Finite element simulations idealize the microstructure as a composite that contains ferrite, martensite and retained austenite. All three phases are discretely modeled using appropriate crystal plasticity based constitutive relations. Material parameters for ferrite and martensite are determined by fitting numerical predictions to the micropillar data. The constitutive relation for retained austenite takes into account contributions to the strain rate from the austenite–martensite transformation, as well as slip in both the untransformed austenite and product martensite. Parameters for the retained austenite are then determined by fitting the predicted flow stress and transformed austenite volume fraction in a 3D microstructure to experimental measurements. Simulations are used to probe the role of the retained austenite in controlling the strain hardening behavior as well as internal stress and strain distributions in the microstructure.