MARINET experiment KNSWING testing an I-Beam OWC attenuator. (December 2015)

• Record Type: Journal Article
• Authors: Nielsen, Kim; Bingham, Harry
• Is Part Of: International journal of marine energy. Volume 12(2015)
• Page Start: 21
• Page End: 34
• Publication Date: 2015-12
• Subjects: Wave energy conversion -- Attenuator OWC -- Experimental performance assessment -- North Sea conditions; Ocean energy resources -- Periodicals; Marine resources -- Periodicals; 333.9164
• DOI: 10.1016/j.ijome.2015.08.005
• Languages: English
• ISSNs: 2214-1669

Abstract

Highlights: A 3 m long model of a 40 chamber OWC attenuator has been tested in scale 1:50. The design and geometry is described. Measured performance data in regular monochromatic waves are presented. Measured performance in short and long crested irregular waves is presented. Abstract: The research and results presented in this paper concerns experiments on wave energy conversion carried out in the one meter deep wave tank at the Hydraulic and Maritime Research Center (HMRC) at University College Cork, Ireland in 2013. The purpose is to investigate how much power an attenuator – a ship shaped wave energy converter facing the waves with its bow – can absorb along its sides in a range of regular and irregular wave conditions. The experiments were carried out in model scale 1:50 resembling the wave conditions and water depth of the Danish part of the North Sea and a 150 m long wave energy converter with 20 Oscillating Water Column (OWC) chambers on each side. The damping applied to each chamber by the Power Take Off (PTO) is modeled by forcing the air through a hole with an area of about 1.3% of the chamber water surface area. The results in irregular wave conditions shows that the converter can absorb more than 2.5 MW of wave power that in wave conditions with significant wave heights of 5 m. A capture width ratio between 20% and 25% was measured in the most frequent wave conditions with average periods between 5 and 7 s with significant wave height of 2 m. In short crested waves the energy absorption was slightly better due to the directional spreading of energy. The tests in monochromatic waves indicate capture width ratios up to 35% in waves with a steepness of 2.5%. The capture width ratio decreases somewhat in steeper waves. The experiments with the attenuator wave energy converter demonstrated its seaworthiness and ability to absorb wave energy. The results form a valuable base for the development of a numerical model of the system that will be used for further optimization and development.