Microscale Solubility Measurements of Matrix-Assisted Laser Desorption–Ionization (MALDI) Matrices Using Attenuated Total Reflection (ATR) Fourier Transform Infrared Spectroscopy (FT-IR) Coupled with Partial Least Squares (PLS) Analysis. Issue 11 (November 2016)

• Record Type: Journal Article
• Authors: Gorre, Elsa; Owens, Kevin G.
• Is Part Of: Applied spectroscopy. Volume 70:Issue 11(2016)
• Page Start: 1831
• Page End: 1841
• Publication Date: 2016-11
• Subjects: Attenuated total reflection Fourier transform infrared spectroscopy (ATR FT-IR) -- MALDI matrix properties -- microscale -- partial least squares -- PLS -- solubility measurement -- Solubility measurement in mixed solvents; Spectrum analysis -- Periodicals; 543.505
• DOI: 10.1177/0003702816647730
• Languages: English
• ISSNs: 0003-7028

Abstract

In this work an attenuated total reflection Fourier transform infrared (FT-IR) absorption based method is used to measure the solubility of two matrix-assisted laser desorption–ionization (MALDI) matrices in a few pure solvents and mixtures of acetonitrile and water using low microliter amounts of solution. Results from a method that averages the values obtained from multiple calibration curves created by manual peak picking are compared to those predicted using a partial least squares (PLS) chemometrics approach. The PLS method provided solubility values that were in good agreement with the manual method with significantly greater ease of analysis. As a test, the solubility of adipic acid in acetone was measured using the two methods of analysis, and the values are in good agreement with solubility values reported in literature. The solubilities of the MALDI matrices α-cyano-4-hydroxy cinnamic acid (CHCA) and sinapinic acid (SA) were measured in a series of mixtures made from acetonitrile (ACN) and water; surprisingly, the results show a highly nonlinear trend. While both CHCA and SA show solubility values of less than 10 mg/mL in the pure solvents, the solubility value for SA increases to 56.3 mg/mL in a 75:25 v/v ACN:water mixture. This can have a significant effect on the matrix-to-analyte ratios in the MALDI experiment when sample protocols call for preparation of a saturated solution of the matrix in the chosen solvent system.