Self-organization of porous anodic alumina films studied in situ by grazing-incidence transmission small-angle X-ray scattering. Issue 34 (23rd May 2018)

• Record Type: Journal Article
• Authors: Evertsson, Jonas; Vinogradov, Nikolay A.; Harlow, Gary S.; Carlà, Francesco; McKibbin, Sarah R.; Rullik, Lisa; Linpé, Weronica; Felici, Roberto; Lundgren, Edvin
• Is Part Of: RSC advances. Volume 8:Issue 34(2018)
• Page Start: 18980
• Page End: 18991
• Publication Date: 2018-05-23
• Subjects: Chemistry -- Periodicals; 540.5
• DOI: 10.1039/c8ra02913j
• Languages: English
• ISSNs: 2046-2069

Abstract

Abstract : Growth of porous anodic alumina films studied in situ under electrochemical anodization conditions by grazing-incidence transmission small-angle X-ray scattering. Abstract : Self-ordered porous anodic alumina (PAA) films are studied extensively due to a large number of possible applications in nanotechnology and low cost of production. Whereas empirical relationships between growth conditions and produced oxides have been established, fundamental aspects regarding pore formation and self-organization are still under debate. We present in situ structural studies of PAA films using grazing-incidence transmission small-angle X-ray scattering. We have considered the two most used recipes where the pores self-organize: 0.3 M H2 SO4 at 25 V and 0.3 M C2 H2 O4 at 40 V. During anodization we have followed the evolution of the structural parameters: average interpore distance, length of ordered pores domains, and thickness of the porous oxide layer. Compared to the extensively used ex situ investigations, our approach gives an unprecedented temporal accuracy in determination of the parameters. By using of Al(100), Al(110) and Al(111) surfaces, the influence of surface orientation on the structural evolution was studied, and no significant differences in the interpore distance and domain length could be observed. However, the rate of oxide growth in 0.3 M C2 H2 O4 at 40 V was significantly influenced by the surface orientation, where the slowest growth occurs for Al(111). In 0.3 M H2 SO4 at 25 V, the growth rates were higher, but the influence of surface orientation was not obvious. The structural evolution was also studied on pre-patterned aluminum surfaces. These studies show that although the initial structures of the oxides are governed by pre-patterning geometry, the final structures are dictated by the anodization conditions.