Dynamic local temperature control in micro‐injection molding: Effects on poly(lactic acid) morphology. Issue 4 (14th December 2017)

• Record Type: Journal Article
• Authors: De Meo, Annarita; De Santis, Felice; Pantani, Roberto
• Is Part Of: Polymer engineering & science. Volume 58:Issue 4(2018)
• Page Start: 586
• Page End: 591
• Publication Date: 2017-12-14
• Subjects: Polymer engineering -- Periodicals; Polymers -- Periodicals; 668.9
• DOI: 10.1002/pen.24784
• Languages: English
• ISSNs: 0032-3888

Abstract

Abstract : Microinjection molding is one of the most efficient processes for wide‐scale production of thermoplastic polymer microparts. The injection molding process with a cold mold suffers from drawbacks, that is, the premature solidification, caused by the small thickness and large temperature difference between the surface of the mold and the incoming polymer. In this work, an original and versatile system to dynamically control the local temperature of the cavity surfaces in microinjection molding was developed. The system was used to investigate the effects of rapid variations of the temperature of a 200 μm thick cavity on the reachable flow length and study the morphology of microinjection molded parts of poly(lactic acid). For the rapid mold temperature control, electrical resistive thin components are located very near the surface of the impression to change the temperature by some tens of degrees per second. This study also demonstrates that the system is able to influence the final morphology of the part with a semicrystalline thermoplastic material. Changing the annealing time and temperature, the effects on the morphology of the part, in the mold and immediately after the injection, were investigated by microscopy analysis and X‐ray diffraction. POLYM. ENG. SCI., 58:586–591, 2018. © 2017 Society of Plastics Engineers