Evaluation of performance of nanofluid using multiwalled carbon nanotubes for machining of Ti–6AL–4V. Issue 3 (4th May 2018)

• Record Type: Journal Article
• Authors: Sahu, Neelesh Kumar; Andhare, Atul B.; Raju, Roja Abraham
• Is Part Of: Machining science and technology. Volume 22:Issue 3(2018)
• Page Start: 476
• Page End: 492
• Publication Date: 2018-05-04
• Subjects: Cutting force -- multiwalled carbon nanotube (MWCNT) -- surface roughness -- Ti–6Al–4V -- tool wear; Machining -- Periodicals; 671.3505
• DOI: 10.1080/10910344.2017.1365898
• Languages: English
• ISSNs: 1091-0344

Abstract

ABSTRACT: Machining of titanium alloys generate very high temperature in the cutting zone. This results in rapid tool wear and poor surface properties. Therefore, improvement in cutting performance in machining of titanium alloys is very much dependent on effectiveness of the cooling strategies applied. In the present work, performance of nanofluid using multiwalled carbon nanotubes (MWCNTs) dispersed in distilled water and sodium dodecyl sulfate (SDS) as surfactant is evaluated for turning operation on Ti–6Al–4V workpieces. Turning operations were carried out under three different conditions – dry, with conventional cutting fluid and with nanofluid. Nanofluid application was limited to 1 L/h and it was applied at the tool tip through gravity feed. Various machining responses like cutting force, surface finish and tool wear were analyzed while turning at optimum cutting parameters as 150 m/min, 0.1 mm/rev and 1 mm depth of cut. Later on, machining performance of nanofluid is confirmed at low cutting speed of 90 m/min. Nanofluid outperformed conventional cutting fluid with 34% reduction in tool wear, average 28% drop in cutting forces and 7% decrease in surface roughness at cutting speed of 150 m/min.