Electrical response of mortar with different degrees of saturation and deicing salt solutions during freezing and thawing. (May 2015)

• Record Type: Journal Article
• Authors: Farnam, Yaghoob; Todak, Heather; Spragg, Robert; Weiss, Jason
• Is Part Of: Cement & concrete composites. Volume 59(2015)
• Page Start: 49
• Page End: 59
• Publication Date: 2015-05
• Subjects: Conductivity -- Damage -- Electrical -- Freeze–thaw -- Resistivity -- Salt; Composite-reinforced concrete -- Periodicals; Concrete -- Periodicals; Composite materials -- Periodicals; Composites de ciment -- Périodiques; Béton -- Périodiques; Composites -- Périodiques; Béton léger -- Périodiques; Cement composites; Composite materials; Composite-reinforced concrete; Concrete; Lightweight concrete; Periodicals; Electronic journals; 620.135
• DOI: 10.1016/j.cemconcomp.2015.03.003
• Languages: English
• ISSNs: 0958-9465

Abstract

Abstract: This paper discusses a series of electrical measurements made on cementitious mortars containing water–NaCl solutions (0–23.3% concentration by mass) over temperatures in the range of 23 °C to −35 °C. Electrical impedance spectroscopy, acoustic emission, and thermal measurements were made during cooling and heating to detect phase changes and resulting damage. The influence of the degree of saturation (DOS) and NaCl solution concentrations are examined. Three phase changes were detected: (1) eutectic phase change (∼−24 °C), (2) ice/water phase change (∼−4 °C to −4 °C), and (3) chemical phase change (∼−4.5 °C to −5.5 °C). While the resistivity is highly dependent on changes in temperature, a drastic increase in resistivity is observed during freezing. Additionally, a comparison of specimens above and below the critical DOS (i.e., the DOS required for damage to occur) shows that resistivity measurements may able to be used to quantify damage.