Effect of sintering temperature on the thermal expansion behavior of ZrMgMo3O12p/2024Al composite. Issue 9 (15th June 2018)

• Record Type: Journal Article
• Authors: Yang, Junrui; Wang, Lei; Tan, Xinrong; Zhi, Qian; Yang, Ruibin; Zhang, Guopeng; Liu, Zhongxia; Ge, Xianghong; Liang, Erjun
• Is Part Of: Ceramics international. Volume 44:Issue 9(2018)
• Page Start: 10744
• Page End: 10752
• Publication Date: 2018-06-15
• Subjects: ZrMgMo3O12 -- ZrMgMo3O12p/2024Al composite -- Microstructure -- Thermal expansion coefficient -- Hardness; Ceramics -- Periodicals; Céramique industrielle -- Périodiques; Ceramics; Periodicals; Electronic journals; 666
• DOI: 10.1016/j.ceramint.2018.03.110
• Languages: English
• ISSNs: 0272-8842

Abstract

Abstract: A 2024Al metal matrix composite with 10 vol% negative expansion ceramic ZrMgMo3 O12 was fabricated by vacuum hot pressing, and the influence of sintering temperature on the microstructure and thermal expansion coefficient (CTE) of alloys was investigated. Experimental results showed that all ZrMgMo3 O12p /2024Al composites sintered at 500–530 °C had a similar reticular structure and exhibited different linear expansion coefficients at 40–150 °C and 150–300 °C. The addition of 10 vol% ZrMgMo3 O12 decreased the CTEs of 2024Al by ~ 16% at 40–150 °C and by ~ 7% at 150–300 °C. This addition also increased the hardness of 2024Al by ~ 23%. The density of the composites and the content of Al2 Cu in ZrMgMo3 O12p /2024Al increased as the sintering temperature increased. The CTEs of the composites decreased, whereas hardness increased. Thermal cycling from 40 °C to 300 °C caused the CTEs of the composites to decrease gradually and reach a stable value after seven cycles. The lowest CTEs of 15.4 × 10 −6 °C −1 at 40–150 °C and 20.1 × 10 −6 °C −1 at 150–300 °C were obtained after 10 thermal cycles and were reduced by ~ 32% and ~ 17%, respectively, compared with the CTE of the 2024Al. Among the current reinforcements, ZrMgMo3 O12 negative expansion ceramics showed the highest efficiency to decrease the CTE of Al matrix composites.