The influence of scan length on fabricating thin-walled components in selective laser melting. (March 2018)

• Record Type: Journal Article
• Authors: Li, Zhonghua; Xu, Renjun; Zhang, Zhengwen; Kucukkoc, Ibrahim
• Is Part Of: International journal of machine tools & manufacture. Volume 126(2018)
• Page Start: 1
• Page End: 12
• Publication Date: 2018-03
• Subjects: Selective laser melting -- Finite element analysis -- Scan length -- Thin-walled part -- Additive manufacturing; Machine-tools -- Periodicals; Manufacturing processes -- Periodicals; Machines-outils -- Périodiques; Fabrication -- Périodiques; Electronic journals; 621.902
• DOI: 10.1016/j.ijmachtools.2017.11.012
• Languages: English
• ISSNs: 0890-6955

Abstract

Abstract: As one of the advanced additive manufacturing (AM) processes, the selective laser melting (SLM) process provides the possibility of manufacturing almost any complex parts in a wide range of metal materials. In the SLM process, undesired distortion and shrinkage are much more likely to occur in forming Ti6Al4V thin-walled parts due to high-temperature gradients and thermal stresses. In this study, a three-dimensional (3D) finite element model based on indirect coupled thermal-structural analysis is applied to study the variations of temperature, stress and strain fields with different scan lengths. At the same time, the corresponding validation experiments were conducted. It was found that the scan length chiefly affects the second peak temperature rather than the highest temperature. The strain is majorly decided by stress generated during the SLM process. The deviations of thin-walled parts are approximately proportional to the scan lengths. The most suitable scan length is between 4 mm and 6 mm for thin-walled components with specified process parameters, in which case the shrinkage per unit is close to zero. Highlights: The paper studied the influence of scan length on fabricating thin-walled components in selective laser melting. It is found that the scan length chiefly affects the second peak temperature rather than the highest temperature. The deviations of the thin-walled parts are approximately proportional to the scan lengths. The most suitable scan length is between 4 mm and 6 mm for the thin-walled components with specified process parameters.