Experimental study of the performance of intumescent coatings exposed to standard and non-standard fire conditions. (January 2018)

• Record Type: Journal Article
• Authors: Lucherini, Andrea; Giuliani, Luisa; Jomaas, Grunde
• Is Part Of: Fire safety journal. Volume 95(2018)
• Page Start: 42
• Page End: 50
• Publication Date: 2018-01
• Subjects: Intumescent coatings -- Thermal resistance -- Heating rates -- Standard and non-standard fire curves -- Steel protection; Fire prevention -- Periodicals; Incendies -- Prévention -- Recherche -- Périodiques; Fire prevention -- Research; Periodicals; 628.92205
• DOI: 10.1016/j.firesaf.2017.10.004
• Languages: English
• ISSNs: 0379-7112

Abstract

Abstract: Three different experimental setups corresponding to three different fire scenarios were used to investigate how different heating conditions and heating rates affect the behaviour of two different thin intumescent coatings (a solvent-based and a water-based paint). Coated steel samples were exposed to different standard and non-standard fire conditions in an electric oven, in a gas furnace and in a cone heater. A common trend was observed in the thermal resistance development of the tested coatings and three phases (inert phase, transient phase and steady phase) were identified according to four critical points: activation, end of reaction, binder exhaustion and steel austenitization point. The results also showed that the water-based paint performed better at low heating rates, while the tested solvent-based paint performed better at high heating rates and did not activate or provide proper insulation at very low heating rates. In summary, the study confirms that the current procedure for the design of intumescent coatings has shortcomings, as different paints have different performances according to the heating conditions and, in particular, according to the fire heating rate. Highlights: Common trend in the thermal resistance development for the tested intumescent coatings based on three general phases and four critical points. Clear difference between the two tested products and importance of the heating conditions on the performance of intumescent coatings. The tested water-based paint had better performance for low heating rates, while the tested solvent-based paint for high heating rates. For very low heating rates, the solvent-based paint did not activate or provide proper insulation to the steel substrate. The current design procedure has shortcomings, as different products have different performances according to the heating conditions.