Influence of laser parameters on micro-hole drilling of Cu50Zr50 amorphous alloys foil. (25th January 2018)

• Record Type: Journal Article
• Authors: Wang, Chuanjie; Xue, Shaoxi; Chen, Gang; Luan, Dong; Wang, Shuting; Wang, Yibin; Wang, Shize; Liu, Jun; Wang, Zhenlong; Zhang, Peng
• Is Part Of: Ferroelectrics. Volume 523(2018)
• Page Start: 61
• Page End: 66
• Publication Date: 2018-01-25
• Subjects: Laser drilling -- micro-hole -- amorphous alloys -- process parameters; Ferroelectricity -- Periodicals; Ferroelectric crystals -- Periodicals; 537
• DOI: 10.1080/00150193.2018.1391557
• Languages: English
• ISSNs: 0015-0193

Abstract

ABSTRACT: In this study, the effect of the laser process parameters on the quality of the drilled holes using Cu50 Zr50 amorphous alloys foils is investigated experimentally. The results indicate that the diameter of the laser drilled micro-hole increases with the increase of the laser power or laser pulse width. The increasing speed decreases when the laser power or laser pulse width reaching thresholds of 120 W or 1.1 ms, respectively. The variation of diameter with the laser defocusing amount is not monotonic changing and dependent on both the laser defocusing amount and the laser power. The diameter of the laser drilled hole reaches a minimum value under the laser defocusing amount of −0.5 mm for all the laser powers. The variation law of diameter with the laser defocusing amount is changing with the laser power. The formation mechanism of the laser drilled hole is analyzed based on the laser beam and the amorphous alloys foils properties.