Plastic shrinkage of mortars with shrinkage reducing admixture and lightweight aggregates studied by neutron tomography. (July 2015)

• Record Type: Journal Article
• Authors: Wyrzykowski, Mateusz; Trtik, Pavel; Münch, Beat; Weiss, Jason; Vontobel, Peter; Lura, Pietro
• Is Part Of: Cement and concrete research. Volume 73(2015)
• Page Start: 238
• Page End: 245
• Publication Date: 2015-07
• Subjects: Curing (A) -- Drying (A) -- Fresh concrete (A) -- Shrinkage (C) -- Neutron tomography; Cement -- Periodicals; Cement -- Research -- Periodicals; Concrete -- Periodicals; Concrete -- Research -- Periodicals; Ciment -- Périodiques; Béton -- Périodiques; Cement; Concrete; Periodicals; 620.135
• DOI: 10.1016/j.cemconres.2015.03.013
• Languages: English
• ISSNs: 0008-8846

Abstract

Abstract: Water transport in fresh, highly permeable concrete and rapid water evaporation from the concrete surface during the first few hours after placement are the key parameters influencing plastic shrinkage cracking. In this work, neutron tomography was used to determine both the water loss from the concrete surface due to evaporation and the redistribution of fluid that occurs in fresh mortars exposed to external drying. In addition to the reference mortar with a water to cement ratio (w/c) of 0.30, a mortar with the addition of pre-wetted lightweight aggregates (LWA) and a mortar with a shrinkage reducing admixture (SRA) were tested. The addition of SRA reduced the evaporation rate from the mortar at the initial stages of drying and reduced the total water loss. The pre-wetted LWA released a large part of the absorbed water as a consequence of capillary pressure developing in the fresh mortar due to evaporation.