Design and analysis of a novel SAW sensor for civil structural health monitoring. Issue 183 (2nd September 2017)

• Record Type: Journal Article
• Authors: Wang, Tianxian; Xie, Liqiang; Xing, Jianchun; Zhu, Xifeng
• Is Part Of: Integrated ferroelectrics. Issue 183(2017)
• Page Start: 8
• Page End: 18
• Publication Date: 2017-09-02
• Subjects: Surface acoustic wave -- delay line -- inter-digital transducer -- coupling of modes; Ferroelectric devices -- Periodicals; Integrated circuits -- Periodicals; 537.244805
• DOI: 10.1080/10584587.2017.1375830
• Languages: English
• ISSNs: 1058-4587

Abstract

ABSTRACT: This paper presents a novel surface acoustic wave sensor for civil structural health monitoring. The sensing chip packaged in a shell is composed of two SAW delay line dice. One is utilized to sense the pressure induced by a gauge, and the other is used to sense the surrounding temperature for temperature compensation. Each SAW delay line die consists of an inter-digital transducer and two open grating reflectors. The SAW devices are analyzed by using coupling of modes model. Then, the devices in different parameters are fabricated on a 128°Y-X cut LiNbO3 substrate by lift-off technique. Finally, a network analyzer is utilized to test the devices. Large signal-to-noise ratio, low loss and clear sharp peaks of the reflection coefficients S 11 in frequency and time domain can be observed. The experimental results matched well with the theoretical analysis by the finite element software COMSOL. The IDT finger pairs number, electrodes number of per reflector and acoustic aperture effect the reflection coefficient S 11 is discussed in detail.