Does humidification improve the micro Gas Turbine cycle? Thermodynamic assessment based on Sankey and Grassmann diagrams. (15th October 2017)

• Record Type: Journal Article
• Authors: Montero Carrero, Marina; De Paepe, Ward; Bram, Svend; Parente, Alessandro; Contino, Francesco
• Is Part Of: Applied energy. Volume 204(2017)
• Page Start: 1163
• Page End: 1171
• Publication Date: 2017-10-15
• Subjects: Micro Gas Turbine -- Micro Humid Air Turbine -- Sankey diagram -- Grassmann diagram -- Exergy analysis; Power (Mechanics) -- Periodicals; Energy conservation -- Periodicals; Energy conversion -- Periodicals; 621.042
• DOI: 10.1016/j.apenergy.2017.05.067
• Languages: English
• ISSNs: 0306-2619

Abstract

Highlights: The Sankey and Grassmann diagrams of an mGT and an mHAT are drawn and presented. Water injection leads to a 1.4% mGT electrical efficiency increase. The saturator acts as an aftercooler enabling greater heat recovery in the recuperator. In the saturator there is an enthalpy gain but a net exergy loss due to evaporation. The total exergy efficiency of the mGT and mHAT are 35.7% and 30.6% respectively. Abstract: Despite appearing as a promising technology for decentralised Combined Heat and Power (CHP), the rather low electrical efficiency of micro Gas Turbines (mGTs) prevents them from being attractive for users with a variable heat demand. Hot water injection in mGTs, achieved by transforming the cycle into a micro Humid Air Turbine (mHAT), allows increasing the electrical efficiency of these units in moments of low heat demand—therefore decoupling heat and electricity production. This paper introduces and compares the Sankey (enthalpy flow) and Grassmann (exergy flow) diagrams of an mGT based on the Turbec T100 and the corresponding mHAT cycle. Results show that the electrical efficiency of the T100 increases by 1.4% absolute points with water injection, while the total exergy efficiency decreases by 5.1%. Although in the saturation tower there is an enthalpy gain, exergy actually decreases in this component due to the increase in entropy related to the evaporation of water. The benefits of water injection mostly rely on the increased heat capacity of the air-vapour mixture, the lower fuel consumption, the larger amount of heat recovered in the recuperator and the reduced power required in the compressor.