Effects of dilution and baseplate strength on stress distributions in multipass welds deposited using low transformation temperature filler alloys. (August 2014)

• Record Type: Journal Article
• Authors: Ramjaun, T. I.; Stone, H. J.; Karlsson, L.; Kelleher, J.; Ooi, S. W.; Dalaei, K.; Rebelo Kornmeier, J.; Bhadeshia, H. K. D. H.
• Is Part Of: Science and technology of welding & joining. Volume 19:Number 6(2014:Aug.)
• Page Start: 461
• Page End: 467
• Publication Date: 2014-08
• Subjects: Transformation induced plasticity, -- Martensitic weld metal, -- Residual stress, -- Welding, -- Neutron diffraction; Welding -- Periodicals; Joints (Engineering) -- Periodicals; Surfaces (Technology) -- Periodicals; 671.52
• DOI: 10.1179/1362171814Y.0000000209
• Languages: English
• ISSNs: 1743-2936

Abstract

Abstract : Transformation plasticity can be utilised to control residual stresses in steel welds. This requires special filler alloys that transform at a sufficiently low temperature to compensate for accumulated thermal contraction strains. However, the welding parameters needed to optimise the effect in multipass joints have yet to be established. This topic has been investigated by characterising the residual stress distribution in multipass welds fabricated with different welding alloys and baseplates using neutron diffraction to assess the effects of dilution and baseplate strength. While the use of richly alloyed weld metal does enhance fatigue performance in single pass joints, the extent of stress relief that can be derived from transformation plasticity is reduced due to incomplete martensitic transformation when further layers are deposited. For all cases studied, compressive stresses were measured in the weld metal with balancing tensile stress in the heat affected zone of the plate. The magnitude of the tension was observed to be a function of the strength of the baseplate. Recommendations are also presented for the combination of welding and material parameters that lead to the optimum exploitation of transformation plasticity as a method for boosting the fatigue performance of multipass welded joints.