Lining structural monitoring in the new underground service of Naples (Italy). (January 2016)

• Record Type: Journal Article
• Authors: Bilotta, Emilio; Russo, Gianpiero
• Is Part Of: Tunnelling and underground space technology. Volume 51(2016)
• Page Start: 152
• Page End: 163
• Publication Date: 2016-01
• Subjects: NATM -- Monitoring -- Steel ribs -- Internal forces -- Tunnelling -- Numerical analyses; Tunneling -- Periodicals; Underground construction -- Periodicals; Tunnels -- Periodicals; Underground areas -- Periodicals; 624.193
• DOI: 10.1016/j.tust.2015.10.034
• Languages: English
• ISSNs: 0886-7798

Abstract

Graphical abstract: Highlights: Tunnelling for underground railways by NATM through unsaturated pyroclastic silty sand. Monitoring the internal forces arising in two instrumented steel ribs. Interpretation and numerical back-analysis of measurements via FEM. Abstract: A new underground stretch connecting two existing lines of the urban railway underground system was built in Naples. The tunnel was excavated by NATM through unsaturated pyroclastic silty sand at relatively large depths, ranging between thirty to eighty metres. The geometry of the section is rather typical with a top part shaped as half a circle and a rectangular bottom. The tunnel was conventionally built with a staged construction: after the full face excavation, a temporary lining composed by horse-shoe steel ribs and sprayed concrete was put in place. Two steel ribs, spaced about one hundred metres apart and located about sixty metres below the ground surface, were instrumented with twenty-four vibrating wire strain gauges, installed at six symmetric locations. Nearly two years of measurements were collected. In the paper the measured strains and the back-calculated internal forces are reported. The results of FE 3D and 2D back-analyses are also shown allowing to throw a light on the observed behaviour.