Selective hydrogenation of alkynes over ppm-level Pd/boehmite/Al2O3 beads in a continuous-flow reactor. Issue 20 (29th September 2017)

• Record Type: Journal Article
• Authors: Wu, Zhilin; Calcio Gaudino, Emanuela; Manzoli, Maela; Martina, Katia; Drobot, Maxime; Krtschil, Ulrich; Cravotto, Giancarlo
• Is Part Of: Catalysis science & technology. Volume 7:Issue 20(2017)
• Page Start: 4780
• Page End: 4791
• Publication Date: 2017-09-29
• Subjects: Catalysis -- Periodicals; 541.395
• DOI: 10.1039/c7cy01542a
• Languages: English
• ISSNs: 2044-4753

Abstract

Abstract : High activity and selectivity to the semi-hydrogenated products for alkyne hydrogenation over ppm-level Pd/boehmite/Al2 O3 beads in a safe continuous-flow reactor. Abstract : A ppm-level Pd/boemite catalyst has been prepared over 3 mm alumina beads and used for the selective hydrogenation of alkynes in a continuous-flow reactor with two modes: closed-loop and flow-through. The flow rates of the alkyne solution and hydrogen gas are critical factors in the control of conversion and selectivity. In closed-loop mode, over 90% selectivity to alkene was achieved at over 90% conversion of phenylacetylene (PA) and 2-butyne-1, 4-diol (ByD) in closed-loop mode, whereas diphenylacetylene (DPA) gave only 83% selectivity to ( Z )-stilbene. The maximum outputs obtained for the hydrogenations of 22 mM PA, DPA and ByD at 60 °C, with 10 vol% H2 gas bubble at atmospheric pressure in the concurrent flow, were 37.8, 37.5 and 47.0 mmol min −1 g −1 Pd, respectively. In flow-through mode, the optimal H2 flow percentage in the concurrent flow was 44–45 vol%, while the optimal H2 /ByD molar ratio was 1.6–1.7 for both concurrent flow rates of 0.4 and 0.7 mL min −1 . 90% selectivity to 2-butene-1, 4-diol was achieved at over 90% ByD conversion. The maximum output was 25.2 mmol min −1 g −1 Pd. Palladium leaching from the catalyst was evaluated in n -hexane and ethanol under the flow conditions over 100 hours of hydrogenation.