Interfacial reaction and wetting behavior of active Ag-Cu filler alloys on surface of cBN grits and its influence on failure patterns of brazed joint. (November 2017)

• Record Type: Journal Article
• Authors: Ghosh, A.; Chattopadhyay, A.K.
• Is Part Of: International journal of refractory metals & hard materials. Volume 68(2017)
• Page Start: 96
• Page End: 103
• Publication Date: 2017-11
• Subjects: cBN -- Active braze alloy (ABA) -- Wetting -- Interfacial reaction -- Ti-segregation -- Strength of brazement; Heat resistant alloys -- Periodicals; Refractory materials -- Periodicals; Metallography -- Periodicals; Alliages réfractaires -- Périodiques; Matériaux réfractaires -- Périodiques; Métallographie -- Périodiques; Heat resistant alloys; Metallography; Refractory materials; Periodicals; Electronic journals; 669.73
• DOI: 10.1016/j.ijrmhm.2017.07.002
• Languages: English
• ISSNs: 0263-4368

Abstract

Abstract: Cubic boron nitride (cBN) abrasive grits are often brazed on steel to produce monolayer grinding wheels. Establishing a strong cBN brazement is a challenge. In the current work, performance of three different active Ag-Cu alloys have been investigated in-depth considering microstructure of alloys, interfacial reaction phase formation and wetting capability of the reaction product towards the alloy. In the current study, all three alloys contain Ti as active element but with different wt%. One of alloys was so chosen that Indium (In) was present as an additional alloying element, which is responsible for its low liquidus temperature, high Young's modulus and good ductility. Segregation of Ti towards the interface was critically examined. To evaluate joint strength, a miniature twin-ring grinding wheel was produced with these alloys. Interestingly, the alloy containing higher Ti, which required higher brazing temp, resulted in intense reaction but with inferior joint strength. On the other hand, the very presence of indium in Ag-Cu alloy, containing low wt% of Ti not only lowered the brazing temperature but also led to effective wetting and higher joint strength. Failure pattern indicates the prevalence of high residual stress at the bond level for the alloy containing the highest percentage of titanium. Highlights: Role of Ti and In in active Ag-Cu alloys and brazing temperature in brazing of cBN with mild steel is investigated. TiN and TiB2 are found as reaction products at cBN-alloy interface but with a typical non-wetting character to Ag-Cu alloy. Ti-segregation is promoted by In in active Ag-Cu alloy having only 1.25 wt% of Ti, producing a thin reaction layer. Ag-Cu-In-Ti alloy with the lowest liquidus point, highest yield point and good ductility produced the strongest brazement. Grit failure was predominantly above bond level when Ag-Cu-In-Ti alloy was used.