Evaluation of alternative filter media for particulate matter emission testing of residential wood heating devices. (3rd October 2017)

• Record Type: Journal Article
• Authors: Allen, George; Rector, Lisa; Butcher, Thomas; Trojanowski, Rebecca
• Is Part Of: Journal of the Air & Waste Management Association. Volume 67:Number 10(2017)
• Page Start: 1055
• Page End: 1060
• Publication Date: 2017-10-03
• Subjects: Air -- Pollution -- Periodicals; Air quality management -- Periodicals; Hazardous wastes -- Management -- Periodicals; Air Pollution -- prevention & control -- Periodicals; Hazardous Waste -- prevention & control -- Periodicals; Waste Management -- Periodicals; 628.5305
• DOI: 10.1080/10962247.2017.1349011
• Languages: English
• ISSNs: 1047-3289

Abstract

ABSTRACT: The performance of Teflon-coated glass fiber filter media (Pallflex Emfab TX40) is evaluated for particulate matter (PM) sampling of residential wood heating devices in a dilution tunnel. Thirty samples of varying duration and PM loading and concentration were collected from an U.S. Environmental Protection Agency (EPA) Method 28 dilution tunnel using dual Method 5G sample trains with untreated glass fiber and Emfab filters. Filters were weighed soon after the end of sampling and again the next day after equilibration at 35% relative humidity (RH). PM concentrations from both types of filters agreed very well with 1-day equilibration, demonstrating that Emfab filters are appropriate for use in measuring PM from residential wood burning appliances in a dilution tunnel and have performance equal to or better than the glass fiber filter media. Agreement between filter media without equilibration was erratic, with PM from glass fiber filter samples varying from slightly less than the Emfab samples to as much as 2.8 times higher. Some of the glass fiber filters lost substantial mass with equilibration, with the highest percent loss at lower filter mass loadings. Mass loss for Emfab samples was a small percentage of the mass and very consistent across the range of mass loadings. Taken together, these results may indicate water uptake on the glass fiber media that is readily removed with 1-day equilibration at moderate RH conditions. Implications : EPA regulations now allow the use of either glass fiber or Teflon filter media for wood appliance PM emission testing. Teflon filter media minimizes the potential for acid-gas PM artifacts on glass fiber filters; this is important as EPA moves toward the use of locally sourced cordwood for testing that may have higher sulfur content. This work demonstrates that the use of Teflon-coated glass fiber filters can give similar PM measurement results to glass fiber filters after 1 day of equilibration. With no equilibration, measured PM from glass fiber filters was usually higher than from Teflon-coated glass fiber filters.