Metal decorated carbon nanotubes for electrocatalytic water splitting. (27th July 2017)

• Record Type: Journal Article
• Authors: Cozzarini, Luca; Bertolini, Gabriele; Šuran-Brunelli, Simone Tommaso; Radivo, Andrea; Bracamonte, Maria Victoria; Tavagnacco, Claudio; Goldoni, Andrea
• Is Part Of: International journal of hydrogen energy. Volume 42:Number 30(2017)
• Page Start: 18763
• Page End: 18773
• Publication Date: 2017-07-27
• Subjects: Water electrolysis -- Carbon nanotubes -- Catalyst -- Hydrogen production; Hydrogen as fuel -- Periodicals; Hydrogène (Combustible) -- Périodiques; Hydrogen as fuel; Periodicals; 665.81
• DOI: 10.1016/j.ijhydene.2017.06.101
• Languages: English
• ISSNs: 0360-3199

Abstract

Abstract: Water is the most abundant, renewable source of hydrogen on our planet. Appropriate catalytic materials are needed to minimize the energy required to electrochemically split the water molecule, and electrode with high specific areas are sought to maximize the electrolyte/electrode interface. We use Carbon Nanotubes (CNTs) bundles as templates for water splitting electrodes fabrication. Appropriate catalyst materials are thermally evaporated on CNTs, to exploit both their good electrical conductivity and large specific area, while optimizing over-potential towards Hydrogen Evolving Reaction (HER) or Oxygen Evolving Reaction (OER) through the deposited catalysts. Electrodes morphology and surface chemistry are characterized, before and after electrolysis, by means of scanning electron microscopy and X-ray photoelectron spectroscopy. Our electrodes are able to perform water oxidation and water reduction near their thermo-dynamical limit. Performances of these electrodes, taking into account the extremely low loading mass of catalytic material (10 −2 mg cm −2 ) with respect to other reported systems, are among the best HER and OER system reported so far. Finally, a working electrolyser, capable to operate at the interesting low voltage of a single AA battery (1.5 V) and output a stable current (>2.0 mA cm −2 ) for at least 20 h, is successfully assembled and tested. Highlights: Catalyst materials are thermally evaporated on carbon nanotubes. Extremely low mass of catalytic material (10 −2 mg cm −2 ) is used. Electrodes morphology and surface chemistry are characterized. An electrolyser capable to operate at 1.5 V is successfully assembled and tested.