Exploring the mid-load potential of ethanol-diesel dual-fuel combustion with and without EGR. (1st May 2017)

• Record Type: Journal Article
• Authors: Pedrozo, Vinícius B.; May, Ian; Zhao, Hua
• Is Part Of: Applied energy. Volume 193(2017)
• Page Start: 263
• Page End: 275
• Publication Date: 2017-05-01
• Subjects: Dual-fuel combustion -- Ethanol -- Alternative fuel -- Diesel engine -- Exhaust emissions -- EGR; Power (Mechanics) -- Periodicals; Energy conservation -- Periodicals; Energy conversion -- Periodicals; 621.042
• DOI: 10.1016/j.apenergy.2017.02.043
• Languages: English
• ISSNs: 0306-2619

Abstract

Highlights: Optimised diesel injection timings were identified for efficient dual-fuel combustion. A pre-injection of diesel prior to the main injection was essential to reduce PRR. High ethanol energy fractions effectively lowered NOx emissions. EGR further reduced NOx emissions with negligible impact on the engine efficiency. Operational cost savings can be achieved and are heavily dependent on fuel prices. Abstract: Dual-fuel combustion has been shown as an effective means to maximise the utilisation of low carbon fuels in conventional diesel engines while simultaneously reducing nitrogen oxides (NOx) and soot emissions. In this framework, a systematic study was performed to optimise the use of ethanol as a partial substitute for diesel fuel and improve the effectiveness of dual-fuel combustion in terms of emissions, efficiency, and operational cost. Investigations were carried out on a single-cylinder common rail heavy-duty diesel engine at three mid-loads of 0.9, 1.2, and 1.5 MPa net indicated mean effective pressure (IMEP). The ethanol energy fraction was varied from 0% to 80% and diesel injection timings were optimised for maximum efficiency. The experiments were conducted with and without cooled exhaust gas recirculation (EGR) to explore the trade-off between exhaust emissions and engine running costs. The results showed the importance of a small pre-injection of diesel prior to the main injection to reduce in-cylinder pressure rise rates (PRR). The use of high ethanol fractions resulted in shorter and delayed combustion process, similar indicated efficiency, and up to 68% lower NOx emissions than conventional diesel combustion. Soot levels varied with different ethanol percentages. Unburnt hydrocarbon (HC) and carbon monoxide (CO) emissions increased with higher amounts of premixed ethanol fuel. The introduction of 25% EGR led to further NOx reductions, decreasing the nitrogen oxides levels of the non-EGR cases by 80%, on average, with little impact on engine efficiency. The overall results indicated that the utilisation of an ethanol fraction of 80% combined with EGR has potential to achieve 88% NOx reduction compared with the baseline conventional diesel combustion without EGR at 1.2 MPa IMEP. A cost-benefit analysis showed that the effectiveness of dual-fuel combustion in terms of cost is heavily dependent on fuel prices (e.g. per litre). The combustion strategy requires a maximum volumetric price ratio between ethanol and diesel fuels equivalent to 60%. Higher relative prices can still be cost-effective depending on the ethanol energy fraction and EGR rate used as a result of reduced aqueous urea solution consumption in the NOx aftertreatment system.