Sintering optimisation of Fe–Si soft magnetic materials processed by metal injection moulding. (15th March 2017)

• Record Type: Journal Article
• Authors: Páez-Pavón, A.; Jiménez-Morales, A.; Rodriguez-Arbaizar, M.; Carreño-Morelli, E.; Torralba, J. M.
• Is Part Of: Powder metallurgy. Volume 60:Number 2(2017)
• Page Start: 112
• Page End: 119
• Publication Date: 2017-03-15
• Subjects: Soft magnetic materials -- iron–silicon alloys -- metal injection moulding -- powder metallurgy; Powder metallurgy -- Periodicals; 671.3705
• DOI: 10.1080/00325899.2017.1289631
• Languages: English
• ISSNs: 0032-5899

Abstract

ABSTRACT: Soft magnetic materials are used in a wide variety of electromagnetic devices such as motors, relays and sensors. Over the years, the devices are becoming smaller. Therefore, it is essential to produce small parts without compromising the final properties. Metal injection moulding (MIM) is a cost-effective technique to produce small and complex soft magnetic parts with optimal mechanical and magnetic performance. These properties can be improved by maximising the sintered density and by the reduction of impurities content. These factors are strongly related to the sintering parameters. The goal of this study is to determine the influence of the sintering parameters on the final properties of iron–silicon soft magnetic alloys processed by metal injection moulding. In this work, two alloys were sintered under different conditions. The effect of the sintering conditions on both mechanical and magnetic properties was evaluated. This paper is part of a special issue on the Advances in Materials and Processing Technologies (AMPT) 2015 and has subsequently been revised and extended before publication in Powder Metallurgy.