High resolution aquifer characterization using crosshole GPR full‐waveform tomography: Comparison with direct‐push and tracer test data. Issue 1 (10th January 2017)

• Record Type: Journal Article
• Authors: Gueting, Nils; Vienken, Thomas; Klotzsche, Anja; van der Kruk, Jan; Vanderborght, Jan; Caers, Jef; Vereecken, Harry; Englert, Andreas
• Is Part Of: Water resources research. Volume 53:Issue 1(2017)
• Page Start: 49
• Page End: 72
• Publication Date: 2017-01-10
• Subjects: ground penetrating radar -- full‐waveform inversion -- tracer test -- direct‐push -- cone penetration test -- aquifer heterogeneity; Hydrology -- Periodicals; 333.91
• DOI: 10.1002/2016WR019498
• Languages: English
• ISSNs: 0043-1397

Abstract

Abstract: Limited knowledge about the spatial distribution of aquifer properties typically constrains our ability to predict subsurface flow and transport. Here we investigate the value of using high resolution full‐waveform inversion of cross‐borehole ground penetrating radar (GPR) data for aquifer characterization. By stitching together GPR tomograms from multiple adjacent crosshole planes, we are able to image, with a decimeter scale resolution, the dielectric permittivity and electrical conductivity of an alluvial aquifer along cross sections of 50 m length and 10 m depth. A logistic regression model is employed to predict the spatial distribution of lithological facies on the basis of the GPR results. Vertical profiles of porosity and hydraulic conductivity from direct‐push, flowmeter and grain size data suggest that the GPR predicted facies classification is meaningful with regard to porosity and hydraulic conductivity, even though the distributions of individual facies show some overlap and the absolute hydraulic conductivities from the different methods (direct‐push, flowmeter, grain size) differ up to approximately one order of magnitude. Comparison of the GPR predicted facies architecture with tracer test data suggests that the plume splitting observed in a tracer experiment was caused by a hydraulically low‐conductive sand layer with a thickness of only a few decimeters. Because this sand layer is identified by GPR full‐waveform inversion but not by conventional GPR ray‐based inversion we conclude that the improvement in spatial resolution due to full‐waveform inversion is crucial to detect small‐scale aquifer structures that are highly relevant for solute transport. Key Points: Highly resolved tomographic images of the subsurface are obtained from GPR full‐waveform inversion Logistic regression is used to translate GPR electrical properties into hydrogeological facies The distribution of GPR facies explains the plume splitting observed in a tracer experiment