Elucidation of the effect of welding speed on melt flows in high-brightness and high-power laser welding of stainless steel on basis of three-dimensional X-ray transmission in situ observation. Issue 3 (4th March 2017)

• Record Type: Journal Article
• Authors: Kawahito, Yousuke; Uemura, Yousuke; Doi, Yuichiro; Mizutani, Masami; Nishimoto, Kouji; Kawakami, Hiroshi; Tanaka, Manabu; Fujii, Hidetoshi; Nakata, Kazuhiro; Katayama, Seiji
• Is Part Of: Welding international. Volume 31:Issue 3(2017)
• Page Start: 206
• Page End: 213
• Publication Date: 2017-03-04
• Subjects: Welding speed -- melt flows -- high-brightness laser welding -- stainless steel -- three-dimensional X-ray transmission in situ observation -- spatters; Welding -- Periodicals; Welding -- Automation -- Periodicals; 671.52
• DOI: 10.1080/09507116.2016.1223204
• Languages: English
• ISSNs: 0950-7116

Abstract

Abstract: This research was performed with the objective of clarifying the effect of welding speed on melt flows during melt-run welding of SUS304 stainless steel plates with a 6-kW power laser beam on the basis of three-dimensional X-ray transmission in situ observation. As welding speed increased from 25 to 250 mm/s, three kinds of welds characterized by porosity formation and no defects or underfilling due to spatters were produced. The average and the maximum values of measured melt flow velocity were 3 and 10 times higher than the welding speed, respectively. Two kinds of circulation flows at the inlet or the tip of a keyhole were confirmed to control heat transfer in a molten pool. It was found that the circulation flows were so sensitive to the welding speed that bubbles resulting in porosity or spatters were often formed. According to X-ray observation of the formation of spatters with tungsten carbide (WC) tracers, as the melt flow rose along the keyhole wall, the velocity was accelerated from 0.24–0.54 m/s near the keyhole inlet. Consequently, the melt flows made the convex surface behind the keyhole grow higher, resulting in spattering.