Numerical analysis and design of slender concrete-filled elliptical hollow section columns and beam-columns. (15th January 2017)

• Record Type: Journal Article
• Authors: Qiu, W.; McCann, F.; Espinos, A.; Romero, M.L.; Gardner, L.
• Is Part Of: Engineering structures. Volume 131(2017:Jan. 15)
• Page Start: 90
• Page End: 100
• Publication Date: 2017-01-15
• Subjects: Composite structures -- Concrete-filled steel tubes -- Design of structures -- Elliptical sections -- EN 1994-1-1 -- Tubular sections; Structural engineering -- Periodicals; Structural analysis (Engineering) -- Periodicals; Construction, Technique de la -- Périodiques; Génie parasismique -- Périodiques; Pression du vent -- Périodiques; Earthquake engineering; Structural engineering; Wind-pressure; Periodicals; 624.105
• DOI: 10.1016/j.engstruct.2016.10.024
• Languages: English
• ISSNs: 0141-0296

Abstract

Highlights: Concrete-filled elliptical hollow section (CFEHS) beam-columns modelled numerically. Extensive parametric study varying key variables across 360 specimens conducted. Results compared to current Eurocode 4 rules for circular and rectangular members. Current rules are suitable for columns in combined compression and uniaxial bending. Recommend to use buckling curves b and c for columns in axial compression. Abstract: A numerical model simulating the behaviour of elliptical concrete-filled columns under either concentric or eccentric compressive load has been developed in ABAQUS. The numerical results have been compared against a range of experimental results for ultimate load, load–deflection behaviour and failure modes, with good agreement observed. An extensive parametric study has been undertaken whereby the slenderness, load eccentricity, cross-sectional geometry and reinforcement ratio of the concrete-filled columns were varied, creating a data set upon which to formulate design guidance since currently there are no specific provisions in the European Standard EN 1994-1-1[1] for the design of concrete-filled steel elliptical section columns or beam-columns. It is shown that the current provisions of EN 1994-1-1[1] for the design of concrete-filled steel columns of circular or rectangular cross-section are also appropriate for the design of members of elliptical cross-section, employing either buckling curve b or c, depending on the level of steel reinforcement. Finally, an assessment is made of the reliability of the design proposals for concrete-filled elliptical hollow section columns and beam-columns.